MID 036 - CID 0323 - FMI 03 Shutdown Lamp short to +batt
Conditions Which Generate This Code:
The Electronic Control Module (ECM) detects excessive current for the shutdown output.
Note: This diagnostic condition cannot be detected when the shutdown output is OFF.
System Response:
The ECM limits the current for the shutdown output to 0.3 amperes. The code is logged.
Possible Performance Effect:
The engine operation is not affected.
Troubleshooting:
Test Step 1. Perform the following diagnostic procedure: "ECM Status Indicator Output"
Results:
- OK - STOP
Caterpillar Information System:
G3406 Engine Gas Pressure Regulator Condensation - Drain
325, 325B and 325L Excavators Travel Motor - Test
G3406 Engine Valve Data Sheet
325, 325B and 325L Excavators Relief Valve (Crossover) - Test and Adjust
3176C and 3196 Engines for Caterpillar Built Machines Cooling System
G3406 Engine Reference Material
3500B Engines for Caterpillar Built Power Modules with the ADEM 2 Electronic Control Module Speed Control
3176C and 3196 Engines for Caterpillar Built Machines General Information
3126B and 3126E Truck Engine Engine Oil Pump - Inspect
G3516B Engines MID 036 - CID 0320 - FMI 08 Engine Speed/Timing signal abnormal
3126B and 3126E Truck Engine Engine Oil Pressure Sensor - Test
3176C and 3196 Engines for Caterpillar Built Machines Engine Design
G3516B Engines MID 036 - CID 0324 - FMI 03 Warning Lamp short to +batt
3500B Engines for Caterpillar Built Power Modules with the ADEM 2 Electronic Control Module Starting Motor System
C-12, C-15 and C-16 Engines for Caterpillar Built Machines CID 0342 FMI 02 Loss of Secondary Engine Speed signal
325, 325B and 325L Excavators Final Drive
G3516B Engines MID 036 - CID 0336 - FMI 02 Incorrect ECS Switch inputs
3034 Engine for Caterpillar Built Machines Basic Engine
3412 Generator Set Engines Speed/Timing Sensor
3500B Engines for Caterpillar Built Power Modules with the ADEM 2 Electronic Control Module Engine Speed/Timing Sensor - Calibrate
G3516B Engines MID 036 - CID 0443 - FMI 03 Crank Terminate Relay short to +batt
Alternator - Delco 21SI Alternator - Disassemble
C-10, C-12, C-15 and C-16 Industrial Engines CID 0320 FMI 11 Speed/Timing Sensor mechanical failure
C-12, C-15 and C-16 Engines for Caterpillar Built Machines CID 0342 FMI 11 Secondary Engine Speed Sensor mechanical failure