Speed/Timing Sensor
Show/hide table
 | |
| Illustration 1 | g00369893 |
Typical schematic of speed and timing sensor | |
While the engine is stopped, install the sensor. Once the sensor is in contact with the flywheel ring gear, turn the sensor counterclockwise to the following distance. ... 195 ± 15 degrees
(1) Clearance between sensor and flywheel ring gear ... .76 ± .15 mm (.030 ± .006 inch)
(2) Install the locknut and tighten the locknut to the following torque. ... 14 ± 1 N·m (124 ± 9 lb in)
Caterpillar Information System:
3034 Engine for Caterpillar Built Machines Basic Engine
G3516B Engines MID 036 - CID 0336 - FMI 02 Incorrect ECS Switch inputs
325, 325B and 325L Excavators Final Drive
C-12, C-15 and C-16 Engines for Caterpillar Built Machines CID 0342 FMI 02 Loss of Secondary Engine Speed signal
3500B Engines for Caterpillar Built Power Modules with the ADEM 2 Electronic Control Module Starting Motor System
G3516B Engines MID 036 - CID 0324 - FMI 03 Warning Lamp short to +batt
G3516B Engines MID 036 - CID 0323 - FMI 03 Shutdown Lamp short to +batt
G3406 Engine Gas Pressure Regulator Condensation - Drain
325, 325B and 325L Excavators Travel Motor - Test
G3406 Engine Valve Data Sheet
325, 325B and 325L Excavators Relief Valve (Crossover) - Test and Adjust
3176C and 3196 Engines for Caterpillar Built Machines Cooling System
3500B Engines for Caterpillar Built Power Modules with the ADEM 2 Electronic Control Module Engine Speed/Timing Sensor - Calibrate
G3516B Engines MID 036 - CID 0443 - FMI 03 Crank Terminate Relay short to +batt
Alternator - Delco 21SI Alternator - Disassemble
C-10, C-12, C-15 and C-16 Industrial Engines CID 0320 FMI 11 Speed/Timing Sensor mechanical failure
C-12, C-15 and C-16 Engines for Caterpillar Built Machines CID 0342 FMI 11 Secondary Engine Speed Sensor mechanical failure
2000/05/08 Improved Caterpillar O-ring Face Seals are Now Available {7555}
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0100 - FMI 02 (for MUI and PEEC Engines)
3500B Engines for Caterpillar Built Power Modules with the ADEM 2 Electronic Control Module Diagnostic Codes
3408E and 3412E Engines for Caterpillar Built Machines Turbocharger Outlet Pressure Sensor
3176C and 3196 Engines for Caterpillar Built Machines Throttle Position Sensor
3126B Engines for Caterpillar Built Machines Engine Oil Pump - Remove
G3406 Engine Alarms and Shutoffs