MID 036 - CID 0336 - FMI 02 Incorrect ECS Switch inputs
Conditions Which Generate This Code:
The Electronic Control Module (ECM) detects an invalid combination of the inputs from the engine control.
System Response:
The shutdown output is activated. The code is logged.
Possible Performance Effect:
If the engine is running, the engine will be shut down.
Troubleshooting:
Test Step 1. Perform the following diagnostic procedure: "Electrical Power Supply"
Results:
- OK - STOP
Caterpillar Information System:
325, 325B and 325L Excavators Final Drive
C-12, C-15 and C-16 Engines for Caterpillar Built Machines CID 0342 FMI 02 Loss of Secondary Engine Speed signal
3500B Engines for Caterpillar Built Power Modules with the ADEM 2 Electronic Control Module Starting Motor System
G3516B Engines MID 036 - CID 0324 - FMI 03 Warning Lamp short to +batt
G3516B Engines MID 036 - CID 0323 - FMI 03 Shutdown Lamp short to +batt
G3406 Engine Gas Pressure Regulator Condensation - Drain
325, 325B and 325L Excavators Travel Motor - Test
G3406 Engine Valve Data Sheet
325, 325B and 325L Excavators Relief Valve (Crossover) - Test and Adjust
3176C and 3196 Engines for Caterpillar Built Machines Cooling System
G3406 Engine Reference Material
3500B Engines for Caterpillar Built Power Modules with the ADEM 2 Electronic Control Module Speed Control
3034 Engine for Caterpillar Built Machines Basic Engine
3412 Generator Set Engines Speed/Timing Sensor
3500B Engines for Caterpillar Built Power Modules with the ADEM 2 Electronic Control Module Engine Speed/Timing Sensor - Calibrate
G3516B Engines MID 036 - CID 0443 - FMI 03 Crank Terminate Relay short to +batt
Alternator - Delco 21SI Alternator - Disassemble
C-10, C-12, C-15 and C-16 Industrial Engines CID 0320 FMI 11 Speed/Timing Sensor mechanical failure
C-12, C-15 and C-16 Engines for Caterpillar Built Machines CID 0342 FMI 11 Secondary Engine Speed Sensor mechanical failure
2000/05/08 Improved Caterpillar O-ring Face Seals are Now Available {7555}
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0100 - FMI 02 (for MUI and PEEC Engines)
3500B Engines for Caterpillar Built Power Modules with the ADEM 2 Electronic Control Module Diagnostic Codes
3408E and 3412E Engines for Caterpillar Built Machines Turbocharger Outlet Pressure Sensor
3176C and 3196 Engines for Caterpillar Built Machines Throttle Position Sensor