Start By:
- Release the pressure in the hydraulic oil system. Refer to Disassembly and Assembly, "Hydraulic System Pressure - Release".
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, all hoses and all tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
- Open side door (1).
Show/hide table
Illustration 2 g01279260 - Disconnect hose assemblies (3). Disconnect harness assemblies (4), (5), (6), (7), and (8). Remove bolts (10) and remove the cab tilt pump and motor (9).
| |
| Illustration 1 | g01279259 |
- Install the cab tilt pump and motor (9) and install bolts (10). Connect hose assemblies (3). Connect harness assemblies (4), (5), (6), (7), and (8).
Show/hide table
Illustration 4 g01279259 - Close side door (1).
| |
| Illustration 3 | g01279260 |