General Information
Show/hide table
图 1 | g01219349 |
动力传动系控制 |
动力传动系 ECM 控制许多功能,并响应来自操作员的控制输入。 此外,ECM 还响应下述来源的信号:
- 发动机 ECM
- 机器 ECM
- 位于驾驶室中的监视器,通过 CAT 数据链路
- SSP(软开关面板)
- 各种开关,包括操纵手柄上的开关和压力开关
- 机器上的各种传感器
ECM 基于这些输入作出决策。 这些决策发送至各种电磁阀,以操作机器。 本手册中对这些操作做了说明。
监视器会通知操作员机器的状态。 此外,监视器允许操作员调整可定制机器操作的参数。 通过进入监视器上的各种菜单,可更改参数。
Caterpillar Information System:
C15 and C18 Engines for Caterpillar Built Machines Rear Power Take-Off (RPTO) - Install - If Equipped
C15 and C18 Engines for Caterpillar Built Machines Rear Power Take-Off (RPTO) - Remove - If Equipped
2003/12/29 A New Torque Specification Is Now Used For The Fitting Assembly In The Pilot Lines Group {5057, 5059}
2004/02/16 Track Roller Groups (Heavy Duty) are Available {4180}
311C-330C, 345B Series II, 365B and 385B Excavators Fuel Tank Water and Sediment - Drain
C15 and C18 Generator Set Engines Inlet and Exhaust Valves - Remove and Install
A19B and A26B Augers Mounting Bracket - Remove and Install
325C Forest Machines Machine Systems Swing Drive - Remove
Conversion of High Flow Work Tools For Operation on High Flow Skid Steer Loaders and Multi Terrain Loaders{1408, 5057, 7553} Conversion of High Flow Work Tools For Operation on High Flow Skid Steer Loaders and Multi Terrain Loaders{1408, 5057, 7553}
311C-330C, 345B Series II, 365B and 385B Excavators Fuel Tank Shutoff and Drain Control
C15 and C18 Generator Set Engines Inlet and Exhaust Valve Springs - Remove and Install
2004/03/29 Special Instruction, REHS1037 , "Installation Instructions for the Electric Fuel Priming Pump on Caterpillar Equipment With the 24 Volt System" has been Revised {1258}
325C Material Handler Maintenance Interval Schedule
311C-330C, 345B Series II, 365B and 385B Excavators Stopping the Engine
M325C Excavator Machine System Fuel Tank
325C Forest Machines Machine Systems Swing Drive - Disassemble
C15 and C18 Engines for Caterpillar Built Machines Flywheel - Remove
C15 and C18 Engines for Caterpillar Built Machines Flywheel - Install
2003/12/29 A New Seal Improves Durability {3282, 3282, 7555}
C15 and C18 Engines for Caterpillar Built Machines Flywheel Housing - Remove and Install
C15 and C18 Engines for Caterpillar Built Machines Flywheel Housing - Remove and Install - Equipped with Rear Power Take-Off
325C Forest Machines Machine Systems Swing Drive - Assemble
2003/12/29 A New Welding Process Improves The Tube Assembly In The Pump Lines {5057}
302.5 Mini Hydraulic Excavator Window Wiper and Washer Control