Fan Drive - Assemble
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install the lip seal (15) with the sealing lip toward the inside of the hub. Put a thin coat of 1P-0808 Multipurpose Grease on the lip of the seal.
Show/hide table
Illustration 2 g00482534 - Install the roller bearing (12) and the spacer (13) in the fan drive pulley (2). Partially fill the cavity that is around the spacer (13 ) with 1P-0808 Multipurpose Grease. Install the roller bearing (14) in the fan drive pulley (2).
Show/hide table
Illustration 3 g00482531 - Install the shaft (7), dowel pin (10), spacer (8), and the grease fitting (9) to the mounting bracket (11).
Show/hide table
Illustration 4 g00482521 - Install the fan drive pulley (2) on the shaft (7). Install the O-ring seal (6) to the fan drive pulley. Install two bolts (4) and the retaining washer (5) in order to secure the fan drive pulley (2) to the shaft (7).
Show/hide table
Illustration 5 g00482516 - Install the fan hub (3) to the fan drive pulley (2). Install six bolts (1) that secure the fan hub (3) to the fan drive pulley (2).
Show/hide table
Illustration 1 | g00482563 |
End By:
- Install the fan drive.
Caterpillar Information System:
3176C Industrial Engine Fan Drive - Disassemble
G3500 Industrial Engines Programming the TCM - Programming a New TCM
3406E and 3456 Industrial Engines Fuel System Primary Filter - Clean/Replace
1999/12/01 Low NO<SUB>X</SUB> Engine Rebuild Information is Available Electronically {1000, 1088}
G3500 Industrial Engines DDT Menu Map
3512B Oil Well Servicing Engines Air Inlet and Exhaust Lines
G3500 Industrial Engines E4
G3500 Industrial Engines E6
G3500 Industrial Engines E2
G3500 Industrial Engines E1
G3500 Industrial Engines E0
365B Excavators Hydraulic System Machine Drift on a Slope - Check
G3500B Engines General Information (Electronic Control System)
2000/02/01 Reporting Incidents ThroughThe Cat Neutral Net {0353, 0373}
G3500B Engines Manifold Air Pressure Sensor
G3500B Engines Detonation Sensor
G3500B Engines Engine Speed/Timing Sensor
G3500B Engines Measuring Inlet Manifold Temperature
G3500B Engines Exhaust Bypass Valve - Adjust
G3500 Engines Valve Lash and Valve Bridge Adjustment
C-10, C-12, 3406E, C-15, C-16 and C-18 Engines - Electronic PTO Installation and Application Remote PTO Accelerator Position Sensor Circuit - Test
2000/01/01 New Basic Cylinder Head Groups Include Premachined Valve Seat Inserts For Improved Reliability {1100}
2000/01/01 New Electronic Control (Detonation Mixing Control Module) Eliminates Erroneous Shutdown Codes {1901}
G3520B Industrial Engines Camshaft Timing