E4
Conditions Which Generate This Code:
There is an attempt to change a customer specified parameter during engine operation. The code is generated because the engine speed must be zero in order for the parameter to be changed.
System Response:
The engine will continue to run. The customer specified parameter will remain at the previously programmed value.
The engine must be stopped in order to change the customer specified parameter.
Test Step 1.
Press the "CLEAR" key on the DDT in order to return to normal operation.
Results:
- OK - Stop.
Caterpillar Information System:
G3500 Industrial Engines E6
G3500 Industrial Engines E2
G3500 Industrial Engines E1
G3500 Industrial Engines E0
365B Excavators Hydraulic System Machine Drift on a Slope - Check
2000/01/10 Download Flash Files By Using The Caterpillar Service Information System (SIS) Or SIS Web {1901, 7620}
1999/12/01 Smoke Emissions from On-Highway Diesel Engines and Roadside Testing {1000, 1088}
C32 Petroleum Generator Sets Engine Rating Definitions
3512B Petroleum Engines Cooling System Operation
3512B Petroleum Engines Turbocharger
3512B Petroleum Engines Aftercooler
3612 and 3616 Engines Governor Drive - Remove - Earlier
3512B Oil Well Servicing Engines Air Inlet and Exhaust Lines
G3500 Industrial Engines DDT Menu Map
1999/12/01 Low NO<SUB>X</SUB> Engine Rebuild Information is Available Electronically {1000, 1088}
3406E and 3456 Industrial Engines Fuel System Primary Filter - Clean/Replace
G3500 Industrial Engines Programming the TCM - Programming a New TCM
3176C Industrial Engine Fan Drive - Disassemble
3176C Industrial Engine Fan Drive - Assemble
G3500B Engines General Information (Electronic Control System)
2000/02/01 Reporting Incidents ThroughThe Cat Neutral Net {0353, 0373}
G3500B Engines Manifold Air Pressure Sensor
G3500B Engines Detonation Sensor
G3500B Engines Engine Speed/Timing Sensor