Fan Drive - Disassemble
Start By:
- Remove the fan drive.
- Remove the six bolts (1) that secure the fan hub (3) to the fan drive pulley (2). Remove the fan hub (3) from the fan drive pulley (2).
Show/hide table
Illustration 2 g00482521 - Remove the O-ring seal (6) from the fan drive pulley. Remove the two bolts (4) and the retaining washer (5) that secures the fan drive pulley (2) to the shaft (7). Remove the fan drive pulley (2) from the shaft (7).
Show/hide table
Illustration 3 g00482531 - Remove the spacer (8), grease fitting (9), dowel pin (10) and the shaft (7) from the mounting bracket (11).
Show/hide table
Illustration 4 g00482534 - Remove the roller bearing (12), spacer (13) and the roller bearing (14) from the fan drive pulley (2).
Show/hide table
Illustration 5 g00482563 - Remove the lip seal (15) from the opposite side of the hub.
Show/hide table
| |
| Illustration 1 | g00482516 |
Caterpillar Information System:
G3500 Industrial Engines Programming the TCM - Programming a New TCM
3406E and 3456 Industrial Engines Fuel System Primary Filter - Clean/Replace
1999/12/01 Low NO<SUB>X</SUB> Engine Rebuild Information is Available Electronically {1000, 1088}
G3500 Industrial Engines DDT Menu Map
3512B Oil Well Servicing Engines Air Inlet and Exhaust Lines
G3500 Industrial Engines E4
G3500 Industrial Engines E6
G3500 Industrial Engines E2
G3500 Industrial Engines E1
G3500 Industrial Engines E0
365B Excavators Hydraulic System Machine Drift on a Slope - Check
2000/01/10 Download Flash Files By Using The Caterpillar Service Information System (SIS) Or SIS Web {1901, 7620}
3176C Industrial Engine Fan Drive - Assemble
G3500B Engines General Information (Electronic Control System)
2000/02/01 Reporting Incidents ThroughThe Cat Neutral Net {0353, 0373}
G3500B Engines Manifold Air Pressure Sensor
G3500B Engines Detonation Sensor
G3500B Engines Engine Speed/Timing Sensor
G3500B Engines Measuring Inlet Manifold Temperature
G3500B Engines Exhaust Bypass Valve - Adjust
G3500 Engines Valve Lash and Valve Bridge Adjustment
C-10, C-12, 3406E, C-15, C-16 and C-18 Engines - Electronic PTO Installation and Application Remote PTO Accelerator Position Sensor Circuit - Test
2000/01/01 New Basic Cylinder Head Groups Include Premachined Valve Seat Inserts For Improved Reliability {1100}
2000/01/01 New Electronic Control (Detonation Mixing Control Module) Eliminates Erroneous Shutdown Codes {1901}