Valve Lifter - Install
安装步骤
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 将气门挺杆总成 (3) 安放到位并安装螺栓 (4) 。
Show/hide table
图 1 | g00639217 |
- 安装供油管 (2) 。
- 确保 O 形密封圈状态良好。 确保 O 形密封圈在护盖 (1) 上放好并安装护盖。
Show/hide table
图 2 | g00639215 |
End By: 安装气门机构。 请参阅 拆解和组装, "气门机构 - 安装"。
Caterpillar Information System:
SR4 and SR4B Generators and Control Panels Before Starting Engine
3612 and 3616 Engines Valve Lifter - Remove
SR500 Generators Tools
3114, 3116, and 3126 Engines for Caterpillar Built Machines Cylinder Head - Remove
330B Excavator Machine System Specifications Recoil Spring
C-10 and C-12 Industrial Engines Electrical Ground Stud
3612 and 3616 Engines Rocker Arm - Assemble
3612 and 3616 Engines Rocker Arm - Disassemble
C-10 and C-12 Truck Engines Inlet Manifold
SR4 and SR4B Generators and Control Panels Caterpillar Monitoring System - For Generator Sets with Electromechanical Control Panels for Switchgear Conversion
C-10 and C-12 Truck Engines Air Compressor
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Diagnostic Codes
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Ignition Keyswitch Circuit and Battery Supply Circuit - Test
3612 and 3616 Engines Valve Lifter - Disassemble
3612 and 3616 Engines Valve Lifter - Assemble
3126B and 3126E On-highway Engines Accelerator Pedal (Throttle) Position Sensor Circuit - Test
3056 Engine for Caterpillar Built Machines Inlet and Exhaust Valve Springs - Remove and Install
SR4 and SR4B Generators and Control Panels Electronic Modular Control Panel II+ with Paralleling (EMCP II+P)
3612 and 3616 Engines Fuel Injector - Remove
3114, 3116, and 3126 Engines for Caterpillar Built Machines Crankshaft Main Bearings - Install
3612 and 3616 Engines Fuel Injector - Install
Caterpillar Monitoring System for Electronic Modular Control Panel CID 0102 FMI 08 Pressure Sensor (Boost) Abnormal Signal - Test
3003, 3013, 3014 and 3024 Industrial Engines Engaging the Driven Equipment
C-10 and C-12 Truck Engines Water Pump