Rocker Arm - Disassemble
拆解步骤
开始:
- 拆下气门机构总成。 请参阅拆解和组装, "气门机构 - 拆卸"。
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
Show/hide table
图 1 | g01297832 |
- 将螺栓 (2) 和垫圈从摇臂轴 (1) 上拆下。
- 在所有组件上做上识别标记,以便于组装。
- 将螺栓和板 (4) 从摇臂轴 (1) 的一端拆下。
- 将摇臂 (3) 从摇臂轴 (1) 上拆下。
- 卸下按钮 (5) 。 从按钮 (5) 上拆卸 O 形密封圈。
Show/hide table
图 2 | g01297835 |
注: O 形密封圈将按钮 (5) 在摇臂上固定好。
Caterpillar Information System:
C-10 and C-12 Truck Engines Inlet Manifold
SR4 and SR4B Generators and Control Panels Caterpillar Monitoring System - For Generator Sets with Electromechanical Control Panels for Switchgear Conversion
C-10 and C-12 Truck Engines Air Compressor
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Diagnostic Codes
SR4 and SR4B Generators and Control Panels Electromechanical Control Panel for Switchgear Conversion
SR4 and SR4B Generators and Control Panels Electronic Modular Control Panel II (EMCP II)
C-10 and C-12 Truck Engines Accessory Drive (Air Compressor)
3612 and 3616 Engines Valve Mechanism - Install
SR4 and SR4B Generators and Control Panels Electronic Modular Control Panel II+ (EMCP II+)
G3500 Engines Gas Pressure Regulator - Remove
3126B Marine Engine Engine Crankcase Breather - Clean
3612 and 3616 Engines Valve Mechanism - Remove
3612 and 3616 Engines Rocker Arm - Assemble
C-10 and C-12 Industrial Engines Electrical Ground Stud
330B Excavator Machine System Specifications Recoil Spring
3114, 3116, and 3126 Engines for Caterpillar Built Machines Cylinder Head - Remove
SR500 Generators Tools
3612 and 3616 Engines Valve Lifter - Remove
SR4 and SR4B Generators and Control Panels Before Starting Engine
3612 and 3616 Engines Valve Lifter - Install
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Ignition Keyswitch Circuit and Battery Supply Circuit - Test
3612 and 3616 Engines Valve Lifter - Disassemble
3612 and 3616 Engines Valve Lifter - Assemble
3126B and 3126E On-highway Engines Accelerator Pedal (Throttle) Position Sensor Circuit - Test