Electrical Ground Stud
Show/hide table
 | |
| Illustration 1 | g00638966 |
The electrical grounding stud is located on the left side of the engine. | |
(1) Nut
- Tighten the outer nut on the ground stud to the following torque. ... 10 ± 3 N·m (89 ± 27 lb in)
(2) Cylinder block
Caterpillar Information System:
3612 and 3616 Engines Rocker Arm - Assemble
3612 and 3616 Engines Rocker Arm - Disassemble
C-10 and C-12 Truck Engines Inlet Manifold
SR4 and SR4B Generators and Control Panels Caterpillar Monitoring System - For Generator Sets with Electromechanical Control Panels for Switchgear Conversion
C-10 and C-12 Truck Engines Air Compressor
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Diagnostic Codes
SR4 and SR4B Generators and Control Panels Electromechanical Control Panel for Switchgear Conversion
SR4 and SR4B Generators and Control Panels Electronic Modular Control Panel II (EMCP II)
C-10 and C-12 Truck Engines Accessory Drive (Air Compressor)
3612 and 3616 Engines Valve Mechanism - Install
SR4 and SR4B Generators and Control Panels Electronic Modular Control Panel II+ (EMCP II+)
G3500 Engines Gas Pressure Regulator - Remove
330B Excavator Machine System Specifications Recoil Spring
3114, 3116, and 3126 Engines for Caterpillar Built Machines Cylinder Head - Remove
SR500 Generators Tools
3612 and 3616 Engines Valve Lifter - Remove
SR4 and SR4B Generators and Control Panels Before Starting Engine
3612 and 3616 Engines Valve Lifter - Install
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Ignition Keyswitch Circuit and Battery Supply Circuit - Test
3612 and 3616 Engines Valve Lifter - Disassemble
3612 and 3616 Engines Valve Lifter - Assemble
3126B and 3126E On-highway Engines Accelerator Pedal (Throttle) Position Sensor Circuit - Test
3056 Engine for Caterpillar Built Machines Inlet and Exhaust Valve Springs - Remove and Install
SR4 and SR4B Generators and Control Panels Electronic Modular Control Panel II+ with Paralleling (EMCP II+P)