Engine Oil Coolers - Install
- Use new O-ring seals and use new gaskets when the engine oil coolers are being installed.
- Attach a suitable lifting device to the engine oil coolers and oil temperature regulator housing (10). The weight of the engine oil coolers and oil temperature regulator housing (10) is approximately
137 kg (302 lb) . Install the engine oil coolers and oil temperature regulator housing (10). Install bolts (8). - Install tube (9).
- Install tube (6) and install tube (5).
- Attach a suitable lifting device to engine oil cooler (1). The weight of engine oil cooler (1) is approximately
30 kg (66 lb) . Install engine oil cooler (1). Install bolts (4). - Connect tube (2) to the elbow.
- Connect harness assembly (3) to the oil outlet cover.
- Install plug (7) into the oil cooler bonnet.
- Fill the cooling system with coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change".
- Fill the engine with oil to the correct level. Refer to Operation and Maintenance Manual, "Engine Oil - Change".
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| |
| Illustration 1 | g00628948 |
Caterpillar Information System:
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Sensors and Electrical Connectors
C9 Engine For Caterpillar Built Machines Engine Oil Filter Base - Install
G3304 and G3306 Engines Turbocharger
3126B Truck Engine Air Compressor - Remove and Install
3126B Truck Engine Fan Drive - Install
C9 Engine For Caterpillar Built Machines Engine Oil Filter Base - Remove
3126B Truck Engine Fan Drive - Remove
3126B Truck Engine Belt Tensioner - Remove and Install
3606 and 3608 Engines Engine Oil Coolers - Remove
3126B Truck Engine Idler Pulley - Install
3126B Truck Engine Idler Pulley - Remove
Caterpillar Monitoring System for Electronic Modular Control Panel Normal Mode
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines General Information
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Service Tools
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Fault Identification
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Troubleshooting Diagnostic Codes
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines CID 100 FMI 2 Pressure Sensor (Engine Oil) Incorrect Signal - Test
3612 and 3616 Engines Engine Oil Coolers - Assemble
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines CID 110 FMI 2 Temperature Sensor (Engine Coolant) Incorrect Signal - Test
3406E Generator Set Engines Safety Signs and Labels
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines CID 111 FMI 3 Fluid Level Sensor (Engine Coolant) Voltage Above Normal - Test
3054 and 3056 Industrial and Generator Set Engines Lifter Group
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines CID 175 FMI 2 Temperature Sensor (Engine Oil) Incorrect Signal - Test
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines CID 175 FMI 3 Temperature Sensor (Engine Oil) Voltage Above Normal - Test