3126B Truck Engine Caterpillar

Fan Drive - Remove

Usage:

3126 6PZ

Removal Procedure

Start By:

Remove the alternator. Refer to Disassembly and Assembly, "Alternator - Remove and Install".

Show/hide table




Illustration 1	g00609660
Typical Example

Show/hide table




Illustration 2	g00609661
Typical Example

Remove two bolts (2) and remove alternator bracket (1) .

If equipped, remove three bolts (3), the washers, and the nuts. Remove refrigerant compressor (4) .

Remove six bolts (5) and the washers. Remove fan drive (6) and front lifting group (7) from the cylinder head assembly.

Caterpillar Information System:

3126B Truck Engine Belt Tensioner - Remove and Install

3606 and 3608 Engines Engine Oil Coolers - Remove

3126B Truck Engine Idler Pulley - Install

3126B Truck Engine Idler Pulley - Remove

Caterpillar Monitoring System for Electronic Modular Control Panel Normal Mode

EMCPII+ for Gas Engines Data Link

EMCPII+ for Gas Engines Component Location

Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines General Information

EMCPII+ for Gas Engines System Communication Module (Customer)

3612 and 3616 Engines Water Pump - Install - Jacket Water Pump

Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Customer Interface Module

SR4 HV and SR4B HV Generators Parallel Operation

C9 Engine For Caterpillar Built Machines Engine Oil Filter Base - Remove

3126B Truck Engine Fan Drive - Install

3126B Truck Engine Air Compressor - Remove and Install

G3304 and G3306 Engines Turbocharger

C9 Engine For Caterpillar Built Machines Engine Oil Filter Base - Install

3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Sensors and Electrical Connectors

3606 and 3608 Engines Engine Oil Coolers - Install

Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines General Information

Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Service Tools

Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Fault Identification

Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Troubleshooting Diagnostic Codes

Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines CID 100 FMI 2 Pressure Sensor (Engine Oil) Incorrect Signal - Test