Turbocharger
Show/hide table
Illustration 1 | g01659915 |
(1) Torque for the locknut ... 45 ± 2 N·m (33 ± 1 lb ft)
Use the following procedure to tighten the compressor clamp assembly (2) and the clamp assembly (3) for the turbine:
- Tighten the clamp assembly to 14 ± 1 N·m (10 ± 1 lb ft).
- Gently tap around the clamp assembly with a soft faced hammer.
- Again, tighten the clamp assembly to 14 ± 1 N·m (10 ± 1 lb ft).
Caterpillar Information System:
3126B Truck Engine Air Compressor - Remove and Install
3126B Truck Engine Fan Drive - Install
C9 Engine For Caterpillar Built Machines Engine Oil Filter Base - Remove
3126B Truck Engine Fan Drive - Remove
3126B Truck Engine Belt Tensioner - Remove and Install
3606 and 3608 Engines Engine Oil Coolers - Remove
3126B Truck Engine Idler Pulley - Install
3126B Truck Engine Idler Pulley - Remove
Caterpillar Monitoring System for Electronic Modular Control Panel Normal Mode
EMCPII+ for Gas Engines Data Link
EMCPII+ for Gas Engines Component Location
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines General Information
C9 Engine For Caterpillar Built Machines Engine Oil Filter Base - Install
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Sensors and Electrical Connectors
3606 and 3608 Engines Engine Oil Coolers - Install
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines General Information
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Service Tools
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Fault Identification
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Troubleshooting Diagnostic Codes
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines CID 100 FMI 2 Pressure Sensor (Engine Oil) Incorrect Signal - Test
3612 and 3616 Engines Engine Oil Coolers - Assemble
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines CID 110 FMI 2 Temperature Sensor (Engine Coolant) Incorrect Signal - Test
3406E Generator Set Engines Safety Signs and Labels
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines CID 111 FMI 3 Fluid Level Sensor (Engine Coolant) Voltage Above Normal - Test