Engine Oil Coolers - Remove
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
- Drain the engine oil from the engine oil coolers into a suitable container for storage or for disposal. Refer to Operation and Maintenance Manual, "Engine Oil - Change".
Show/hide table
Illustration 1 g00628948 Note: Remove plug (7) from the oil cooler bonnet in order to drain the coolant from the engine oil coolers.
- Drain the coolant from the cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change".
- Disconnect harness assembly (3) from the oil outlet cover.
- Disconnect tube (2) from the elbow.
- Attach a suitable lifting device to engine oil cooler (1), if necessary. The weight of engine oil cooler (1) is approximately
30 kg (66 lb) . Remove bolts (4). Remove engine oil cooler (1). - Remove tube (5) and remove tube (6).
- Remove tube (9).
- Attach a suitable lifting device to the engine oil coolers and oil temperature regulator housing (10). The weight of the engine oil coolers and oil temperature regulator housing (10) is approximately
137 kg (302 lb) . Remove bolts (8). Remove the engine oil coolers and oil temperature regulator housing (10).
Caterpillar Information System:
3126B Truck Engine Idler Pulley - Install
3126B Truck Engine Idler Pulley - Remove
Caterpillar Monitoring System for Electronic Modular Control Panel Normal Mode
EMCPII+ for Gas Engines Data Link
EMCPII+ for Gas Engines Component Location
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines General Information
EMCPII+ for Gas Engines System Communication Module (Customer)
3612 and 3616 Engines Water Pump - Install - Jacket Water Pump
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Customer Interface Module
SR4 HV and SR4B HV Generators Parallel Operation
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Synchronizing Lights Module
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Relay Driver Module
3126B Truck Engine Belt Tensioner - Remove and Install
3126B Truck Engine Fan Drive - Remove
C9 Engine For Caterpillar Built Machines Engine Oil Filter Base - Remove
3126B Truck Engine Fan Drive - Install
3126B Truck Engine Air Compressor - Remove and Install
G3304 and G3306 Engines Turbocharger
C9 Engine For Caterpillar Built Machines Engine Oil Filter Base - Install
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Sensors and Electrical Connectors
3606 and 3608 Engines Engine Oil Coolers - Install
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines General Information
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Service Tools
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Fault Identification