Idler Pulley - Install
Installation Procedure
- Position idler pulley (3). Install bolt (2) and tighten bolt (2) to a torque of 55 ± 10 N·m (40 ± 7 lb ft).
Show/hide table
 | |
| Illustration 1 | g00618473 |
Typical Example | |
- Install a new cover (1) on idler pulley (3) .
Show/hide table
 | |
| Illustration 2 | g00618468 |
Typical Example | |
Caterpillar Information System:
3126B Truck Engine Idler Pulley - Remove
Caterpillar Monitoring System for Electronic Modular Control Panel Normal Mode
EMCPII+ for Gas Engines Data Link
EMCPII+ for Gas Engines Component Location
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines General Information
EMCPII+ for Gas Engines System Communication Module (Customer)
3612 and 3616 Engines Water Pump - Install - Jacket Water Pump
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Customer Interface Module
SR4 HV and SR4B HV Generators Parallel Operation
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Synchronizing Lights Module
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Relay Driver Module
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Alarm Module Control (Custom)
3606 and 3608 Engines Engine Oil Coolers - Remove
3126B Truck Engine Belt Tensioner - Remove and Install
3126B Truck Engine Fan Drive - Remove
C9 Engine For Caterpillar Built Machines Engine Oil Filter Base - Remove
3126B Truck Engine Fan Drive - Install
3126B Truck Engine Air Compressor - Remove and Install
G3304 and G3306 Engines Turbocharger
C9 Engine For Caterpillar Built Machines Engine Oil Filter Base - Install
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Sensors and Electrical Connectors
3606 and 3608 Engines Engine Oil Coolers - Install
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines General Information
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Service Tools