Fan Drive - Install
Installation Procedure
- Position fan drive (6) and front lifting group (7) on the cylinder head assembly. Install six bolts (5) and the washers.
Show/hide table
Illustration 1 | g00609660 |
Typical Example |
Show/hide table
Illustration 2 | g00609661 |
Typical Example |
- If equipped, position refrigerant compressor (4). Install three bolts (3), the washers, and the nuts.
- Position alternator bracket (1). Install two bolts (2) .
End By: Install the alternator. Refer to Disassembly and Assembly, "Alternator - Remove and Install".
Caterpillar Information System:
C9 Engine For Caterpillar Built Machines Engine Oil Filter Base - Remove
3126B Truck Engine Fan Drive - Remove
3126B Truck Engine Belt Tensioner - Remove and Install
3606 and 3608 Engines Engine Oil Coolers - Remove
3126B Truck Engine Idler Pulley - Install
3126B Truck Engine Idler Pulley - Remove
Caterpillar Monitoring System for Electronic Modular Control Panel Normal Mode
EMCPII+ for Gas Engines Data Link
EMCPII+ for Gas Engines Component Location
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines General Information
EMCPII+ for Gas Engines System Communication Module (Customer)
3612 and 3616 Engines Water Pump - Install - Jacket Water Pump
3126B Truck Engine Air Compressor - Remove and Install
G3304 and G3306 Engines Turbocharger
C9 Engine For Caterpillar Built Machines Engine Oil Filter Base - Install
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Sensors and Electrical Connectors
3606 and 3608 Engines Engine Oil Coolers - Install
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines General Information
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Service Tools
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Fault Identification
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Troubleshooting Diagnostic Codes
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines CID 100 FMI 2 Pressure Sensor (Engine Oil) Incorrect Signal - Test
3612 and 3616 Engines Engine Oil Coolers - Assemble
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines CID 110 FMI 2 Temperature Sensor (Engine Coolant) Incorrect Signal - Test