Accessory Drive Gears (Rear)
Show/hide table
图 1 | g01347490 |
(1) 适配器组件 (2) 驱动齿轮 (3) 惰齿轮组件 (4) 泵适配器 (5) 曲轴齿轮 |
Show/hide table
图 2 | g01347492 |
(A) 按照以下角度安装轴承接头。 ... 37.5 ± 1.0 度
注: 测量距适配器壳体两个螺栓中心线的角度 (A) 。
注: 松放轴承时必须与齿轮的松放在 2 度以内。 轴承不得伸出任一齿轮表面。
Show/hide table
图 3 | g01347494 |
(C) 按照以下角度安装轴承接头。 ... 15 ± 1 度
注: 测量距适配器壳体垂直中心线的角度 (B) 。
Show/hide table
图 4 | g01347495 |
剖面 B-B |
(D) 安装前衬套轴承外径 ... 69.952 ± 0.020 mm (2.7540 ± 0.0008 in)
(E) 衬套轴承端与适配器壳体边缘之间的距离 ... 3.5 ± 0.5 mm (0.14 ± 0.02 in)
Caterpillar Information System:
S3 Shear and CR3 Crusher Housing
S3 Shear and CR3 Crusher Crushing Arm
307B Excavator Machine Systems Cab Heater - Remove
307B Excavator Machine Systems Gear Pump (Pilot) - Disassemble
BA18 Angle Broom Broom Angle Adjustment
LR15 and LR18 Landscape Rakes Safety Signs and Labels
LR15 and LR18 Landscape Rakes Walk-Around Inspection
S25/S225, S30/S230, S40/S240, S50/S250, S80/S280 and S130/S2130 Demolition and Scrap Shears Standard Torque for Inch Fasteners
PC3 and PC4 Cold Planers Mounting Plate For Frame (Rear) - Lubricate
A19 Auger Gearbox Oil Level - Check
A19 Auger Gearbox Oil - Change
BP15 Pickup Broom Safety Signs and Labels
S3 Shear and CR3 Crusher Cutter
322B, 322B L, 325B and 325B L Excavators Condenser (Refrigerant) - Clean
315B L, 317B L and 317B LN Excavators Attachment Hydraulic System Combined Function Hydraulic Operation - Ball Valves
3046 Engine For Caterpillar Built Machines Crankshaft - Remove
307B Excavator Machine Systems Counterweight - Remove and Install
325B Excavator Machine Systems Accumulator (Hydraulic Pilot) - Remove and Install
5230 Excavator Hydraulic System Cooling System
315B L, 317B L and 317B LN Excavators Attachment Hydraulic System Combined Function Hydraulic Operation - Front Lines Group
Caterpillar Monitoring System Service Mode
325B Excavator Machine Systems Solenoid Valve (Proportional Reducing) - Remove and Install
3046 Engine For Caterpillar Built Machines Crankshaft - Install
320B Excavator Hydraulic System General Information