BA18 Angle Broom Caterpillar

Show/hide table

No clearance for person in this area during operation. Severe injury or death from crushing could occur. Stay away from the work tool while it is in operation.

Adjustment for Manual Configuration

Show/hide table



Illustration 1	g00586710

1. Remove pin (2) from linkage (1) .

2. Position the broom to the desired angle.

3. Install the pin.

Adjustment for Hydraulic Configuration

Note: Electrical tool control package must be installed for hydraulic angling.

1. Press the auxiliary hydraulic control to the AUX 1 in order to rotate the broom.

2. Activate the auxiliary electrical control for the diverter valve in order to direct flow to the angle cylinder until the desired angle is obtained. Press auxiliary electrical control to the AUX LEFT in order to angle the broom frame to the left. Press auxiliary electrical control to the AUX RIGHT in order to angle the broom frame to the right.

3. Release the auxiliary electrical control for the diverter valve in order to continue with normal broom operation.