Cab Heater - Remove
Start By:
- Remove the seat assembly. Refer to Disassembly and Assembly, "Seat - Remove" in this manual.
Show/hide table
At operating temperature, the engine coolant is hot and under pressure. Steam can cause personal injury. Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand. Remove the fill cap slowly to relieve pressure. Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury. |
- Release the pressure in the cooling system.
Show/hide table
Illustration 1 g00550185 - Remove the bolts (1), the washers, and the cover (2) from the underside of the cab.
Show/hide table
Illustration 2 g00550784 Typical example - Loosen the two clamps, and disconnect hose assemblies (3) and (4) from the two tubes under the cab heater. Put plugs in the hose assemblies in order to prevent coolant loss.
Show/hide table
Illustration 3 g00550186 - Disconnect the wiring harness (5) behind the cab heater.
Show/hide table
Illustration 4 g00550722 - Remove four bolts (6) and the washers that hold the cab heater (7) to the floorplate. Remove the cab heater.
Caterpillar Information System:
307B Excavator Machine Systems Gear Pump (Pilot) - Disassemble
BA18 Angle Broom Broom Angle Adjustment
LR15 and LR18 Landscape Rakes Safety Signs and Labels
LR15 and LR18 Landscape Rakes Walk-Around Inspection
S25/S225, S30/S230, S40/S240, S50/S250, S80/S280 and S130/S2130 Demolition and Scrap Shears Standard Torque for Inch Fasteners
PC3 and PC4 Cold Planers Mounting Plate For Frame (Rear) - Lubricate
A19 Auger Gearbox Oil Level - Check
A19 Auger Gearbox Oil - Change
BP15 Pickup Broom Safety Signs and Labels
BP15 Pickup Broom Walk-Around Inspection
BP15 Pickup Broom Transport Position
BP15 Pickup Broom Skirts - Inspect/Adjust/Replace
S3 Shear and CR3 Crusher Crushing Arm
S3 Shear and CR3 Crusher Housing
3306C Engines for Caterpillar Built Machines Accessory Drive Gears (Rear)
S3 Shear and CR3 Crusher Cutter
322B, 322B L, 325B and 325B L Excavators Condenser (Refrigerant) - Clean
315B L, 317B L and 317B LN Excavators Attachment Hydraulic System Combined Function Hydraulic Operation - Ball Valves
3046 Engine For Caterpillar Built Machines Crankshaft - Remove
307B Excavator Machine Systems Counterweight - Remove and Install
325B Excavator Machine Systems Accumulator (Hydraulic Pilot) - Remove and Install
5230 Excavator Hydraulic System Cooling System
315B L, 317B L and 317B LN Excavators Attachment Hydraulic System Combined Function Hydraulic Operation - Front Lines Group
Caterpillar Monitoring System Service Mode