Walk-Around Inspection
Show/hide table
NOTICE |
---|
Accumulated grease and oil on a work tool is a fire hazard. Remove debris with steam cleaning or high pressure water at any time a significant quantity of oil is spilled on the work tool. |
Note: Watch closely for leaks. If a leak is observed, find the source of the leak and correct the leak. If a leak is suspected or a leak is observed, check the fluid levels more frequently.
Show/hide table
Illustration 1 | g00556440 |
- Inspect the conveyor chain (7) for damage or for excessive wear. Replace the conveyor chain, if necessary.
- Inspect the gerotor motor (3) for any leaks. Correct any leaks.
- Inspect the hydraulic system (4) for leaks. Inspect the manifold for leaks. Repair any hydraulic system leaks. Inspect the hoses, the seals, and the flanges.
- Inspect the bucket (5) for loose bolts, for missing bolts and for worn bolts. Inspect the cover (1) for loose bolts, for missing bolts and for worn bolts. Tighten any loose bolts. Replace any missing bolts or any worn bolts.
- Inspect the lift cylinder (2) for wear and for damage. Inspect the pivot block for wear and for damage. Perform any necessary repairs.
- Inspect the nylon abrasion coverings for wear and for damage. Replace any damaged clamps or any missing clamps. Replace the nylon abrasion coverings, if necessary.
- Inspect the skids (6) for wear and for damage. Perform any necessary repairs. Replace any missing bolts or any damaged bolts.
- Inspect the condition of the mounting bracket before you install the work tool onto the host machine. Refer to Operation and Maintenance Manual, "Mounting Bracket - Inspect" for more detailed information.
Caterpillar Information System:
S25/S225, S30/S230, S40/S240, S50/S250, S80/S280 and S130/S2130 Demolition and Scrap Shears Standard Torque for Inch Fasteners
PC3 and PC4 Cold Planers Mounting Plate For Frame (Rear) - Lubricate
A19 Auger Gearbox Oil Level - Check
A19 Auger Gearbox Oil - Change
BP15 Pickup Broom Safety Signs and Labels
BP15 Pickup Broom Walk-Around Inspection
BP15 Pickup Broom Transport Position
BP15 Pickup Broom Skirts - Inspect/Adjust/Replace
BP15 Pickup Broom Shipping the Work Tool
BP15 Pickup Broom Serial Number and EU's CE Plate Location
BP15 Pickup Broom Pivot Pin (Frame) - Lubricate
BP15 Pickup Broom Pickup Broom Operation
LR15 and LR18 Landscape Rakes Safety Signs and Labels
BA18 Angle Broom Broom Angle Adjustment
307B Excavator Machine Systems Gear Pump (Pilot) - Disassemble
307B Excavator Machine Systems Cab Heater - Remove
S3 Shear and CR3 Crusher Crushing Arm
S3 Shear and CR3 Crusher Housing
3306C Engines for Caterpillar Built Machines Accessory Drive Gears (Rear)
S3 Shear and CR3 Crusher Cutter
322B, 322B L, 325B and 325B L Excavators Condenser (Refrigerant) - Clean
315B L, 317B L and 317B LN Excavators Attachment Hydraulic System Combined Function Hydraulic Operation - Ball Valves
3046 Engine For Caterpillar Built Machines Crankshaft - Remove
307B Excavator Machine Systems Counterweight - Remove and Install