Carburetor - Remove - High Pressure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Turn OFF the gas supply.
- Disconnect tube (2) and control rod (4) from carburetor (3).
- Remove clamp (5).
- Remove bolts (1) and the gasket.
- Remove carburetor (3) and the gasket.
Show/hide table
Illustration 1 | g00597082 |
Typical example |
Caterpillar Information System:
3064 and 3066 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Disassemble
G3500 Engines Exhaust Elbow - Remove and Install
3612 and 3616 Engines Water Pump - Sea Water
3612 and 3616 Engines Water Pump
G3500 Engines Exhaust Elbow - Remove and Install
3500B Engines Expansion Tank - Remove and Install
G3500 Engines Exhaust Bypass Valve - Remove and Install
3034 Engine for Caterpillar Built Machines Turbocharger - Remove
3406E and 3456 Generator Set Engines Alternator - Remove and Install
3500B Engines Electric Starting Motor - Remove and Install
Electronic Modular Control Panel II (EMCP II) For PEEC Engines CID 330 FMI 7 Unexpected Shutdown Improper Mechanical Response - Test
G3500 Engines Exhaust Manifold - Install - Water Cooled
G3500 Engines Carburetor - Remove - Low Pressure
G3606 and G3608 Engines Junction Box (Hydrax) - Remove and Install
3500B Engines Exhaust Elbow - Remove and Install
3524B Engine for Caterpillar Built Machines Crankcase Breather - Remove and Install
G3500 Engines Carburetor - Remove - Low Pressure
G3500 Engines Carburetor - Install - High Pressure
G3500 Engines Carburetor - Install - Low Pressure
G3500 Engines Carburetor - Install - Low Pressure
G3606 and G3608 Engines Hydraulic Oil Pump (Hydrax) - Remove and Install
G3500 Engines Carburetor - Disassemble - High Pressure
3508, 3508B, 3508C, 3512, 3512B, 3512C, 3516, 3516B and 3516C Engines Caterpillar Monitoring System Harness Code - Troubleshoot
G3606 and G3608 Engines Hydraulic Tank (Hydrax) - Remove and Install