Exhaust Manifold - Install - Water Cooled
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Use a suitable lifting device to position the exhaust manifold on the engine. Ensure that the gaskets are in the proper position.
Show/hide table
Illustration 2 g00596758 Show/hide tableIllustration 3 g00596757 - Install bolts (7), (8), and (9).
Show/hide table
Illustration 4 g00596755 - Install bolts (5).
Show/hide table
Illustration 5 g00596756 - Install tube (6).
Show/hide table
Illustration 6 g00596753 - Install tubes (1) and (4). Install clamp (3).
Show/hide table
Illustration 7 g00596844 - Install clamp (2) and connect tube (1) to the gas pressure regulator.
- Turn on the gas supply.
Show/hide table
Illustration 1 | g00596759 |
End By:
- Install the aftercooler.
- Install the turbochargers.
Caterpillar Information System:
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 269 FMI 4 Sensor Power Supply Voltage Below Normal - Test
G3500 Engines Exhaust Manifold - Remove - Water Cooled
G3606 and G3608 Engines Turbocharger - Assemble
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 269 FMI 3 Sensor Power Supply Voltage Above Normal - Test
3500B Engines Alternator - Remove and Install
G3500 Engines Aftercooler - Remove and Install
Electronic Modular Control Panel II (EMCP II) For PEEC Engines CID 248 FMI 9 CAT Data Link Abnormal Update - Test
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Coolant Temperature Switch - Remove and Install
Electronic Modular Control Panel II (EMCP II) For PEEC Engines CID 190 FMI 3 Speed Sensor (Engine) Voltage Above Normal - Test
3114, 3116, and 3126 Engines for Caterpillar Built Machines Engine Oil Pan - Remove and Install
3126B Marine Engine Vibration Damper
Electronic Modular Control Panel II (EMCP II) For PEEC Engines CID 190 FMI 2 Speed Sensor (Engine) Incorrect Signal - Test
Electronic Modular Control Panel II (EMCP II) For PEEC Engines CID 330 FMI 7 Unexpected Shutdown Improper Mechanical Response - Test
3500B Engines Electric Starting Motor - Remove and Install
3406E and 3456 Generator Set Engines Alternator - Remove and Install
3034 Engine for Caterpillar Built Machines Turbocharger - Remove
G3500 Engines Exhaust Bypass Valve - Remove and Install
3500B Engines Expansion Tank - Remove and Install
G3500 Engines Exhaust Elbow - Remove and Install
3612 and 3616 Engines Water Pump
3612 and 3616 Engines Water Pump - Sea Water
G3500 Engines Exhaust Elbow - Remove and Install
3064 and 3066 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Disassemble
G3500 Engines Carburetor - Remove - High Pressure