Alternator - Remove and Install
Removal Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Turn the battery disconnect switch to the OFF position.
- Put identification on the harness assemblies for installation purposes. Remove the harness assemblies from alternator (3) .
Show/hide table
Illustration 1 | g00596882 |
Show/hide table
Illustration 2 | g00596913 |
- Loosen nuts (5) on the adjustment rod.
- Loosen the nut on bolt (1). Push the top of the alternator toward the cylinder block. Remove V-belt (2) .
- Remove bolts (1) and (4). Remove alternator (3) .
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Put alternator (3) in position on the alternator bracket and install bolt (1) .
Show/hide table
Illustration 3 | g00596882 |
Show/hide table
Illustration 4 | g00596913 |
- Put the adjustment rod in position on the alternator and install bolt (4) .
- Install V-belt (2). Tighten the V-belt. Refer to Testing and Adjusting, "Belt Tension Chart".
- Tighten nuts (5) to a torque of 30 ± 15 N·m (22 ± 11 lb ft).
- Install the harness assemblies on the alternator.
- Turn the battery disconnect switch to the ON position.
Caterpillar Information System:
3500B Engines Electric Starting Motor - Remove and Install
Electronic Modular Control Panel II (EMCP II) For PEEC Engines CID 330 FMI 7 Unexpected Shutdown Improper Mechanical Response - Test
G3500 Engines Exhaust Manifold - Install - Water Cooled
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 269 FMI 4 Sensor Power Supply Voltage Below Normal - Test
G3500 Engines Exhaust Manifold - Remove - Water Cooled
G3606 and G3608 Engines Turbocharger - Assemble
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 269 FMI 3 Sensor Power Supply Voltage Above Normal - Test
3500B Engines Alternator - Remove and Install
G3500 Engines Aftercooler - Remove and Install
Electronic Modular Control Panel II (EMCP II) For PEEC Engines CID 248 FMI 9 CAT Data Link Abnormal Update - Test
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Coolant Temperature Switch - Remove and Install
Electronic Modular Control Panel II (EMCP II) For PEEC Engines CID 190 FMI 3 Speed Sensor (Engine) Voltage Above Normal - Test
3034 Engine for Caterpillar Built Machines Turbocharger - Remove
G3500 Engines Exhaust Bypass Valve - Remove and Install
3500B Engines Expansion Tank - Remove and Install
G3500 Engines Exhaust Elbow - Remove and Install
3612 and 3616 Engines Water Pump
3612 and 3616 Engines Water Pump - Sea Water
G3500 Engines Exhaust Elbow - Remove and Install
3064 and 3066 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Disassemble
G3500 Engines Carburetor - Remove - High Pressure
G3500 Engines Carburetor - Remove - Low Pressure
G3606 and G3608 Engines Junction Box (Hydrax) - Remove and Install
3500B Engines Exhaust Elbow - Remove and Install