Correction To Service Manual Modules SENR6059 And SENR1371 {7601,7603}
Usage:
5130 (5ZL, 7TJ),
5130B (4CS),
5230 (7LL) Excavators;
784B (5RK) Tractor;
785B (6HK),
789B (7EK),
793B (1HL),
793C (4AR) Trucks;
992G (7HR),
994 (9YF) Wheel loaders
Service Manual Module SENR6059-04; December 1997; Vital Information Management System; Page 105 and Service Manual Module SENR1371; April 1997; Vital Information Display System; Page 60, incorrectly identify CID 0427 in the Component Identification (CID) Chart as "Front Axle Oil Pressure Sensor". It should read "Front Axle Oil Temperature Sensor".
Caterpillar Information System:
1998/04/13 New Relief Valve For Main Hydraulic System Improves Maintaining Pressure Setting {5069}
1998/04/06 Improved Duct Assembly Enhances Air Conditioning Of Cab {7309,7320}
1998/04/06 Carbody Side Plates Reinforced To Increase Service Life {7062}
1998/04/06 Further Improvements To Retention System For Excavator Tips And Couplers {6500,6515,6537,6800}
1998/04/06 New Butyl Cab Mount Used To Reduce Cab Vibration {7260}
1998/04/06 Track Roller Break In And Travel Procedures {4154,4159,4180}
1998/04/06 New Line Relief Valve Prevents Seal Failure And Loss Of Line Relief Valve Pressure {5080,5090,5117}
1998/04/06 Magnet Used To Secure Electric Panel Door During VIMS Real Time Analysis Procedure {1417,7301}
1998/04/06 Spools And Valves In The Main Hydraulic Control Valve Are Now Serviceable {5051}
1998/04/06 Support Plates Improve Track Frames {4151,4154}
1998/04/06 New Push Rods In The Pilot Control Valve Improve Service Life {5059,5465,5466}
1998/03/30 Service Interval Change For Balderson/Caterpillar Hydraulic Hammers {5488}
1998/04/13 Improved Rod In Bottom Dump Cylinder Group For Bucket {5457}
1998/04/20 Optional Valve Spool Kits Are Available For The Pilot Valve Group To Modify The Response Of Implement Controls{5059,5462,5465,5466}
1998/04/20 Improved Ground Engaging Tool (GET) Pin And Retainer Assembly Are Available{6805}
1998/04/20 The Swing Bearing In The Bearing And Gear Group Is Improved{7063,5459}
1998/04/20 Additional Clip In Fuel Injection Lines Groups Helps Secure Advanced Diesel Engine Management (ADEM) I Electronic Control Module (ECM) Fuel Cooling Hose{1252}
1998/04/20 Oil Filter Group Changed To Allow Oil To Be Easily Drained From Oil Lines{1307}
1998/04/20 Oil Filter Group Changed To Allow Oil To Be Easily Drained From Oil Lines{1307}
1998/04/27 New Design Improves Travel Motor Regulator {4351}
1998/04/27 New Relief Valves In Main Control Valve Improve Swing Operation {5051,5454}
1998/04/27 New Hardened Sleeve For Load Check Valve In Control Valve For Stick Circuit Improves Service Life {5067}
1998/05/04 Special Instructions Are now Available For Installing Two-Way And Four-Way Pilot Valves{5051,5059}
1998/05/04 New Retaining Ring In Final Drive Motor Group Improves Reliability{5058}