Fuel Filter (Primary)
Show/hide table
图 1 | g00579790 |
典型实例 |
(1) 将螺母拧紧至以下扭矩。 ... 24.5 ± 4.1 N·m (18 ± 3 lb ft)
(2) 7S-9323 弹簧
- 测试力作用下的弹簧长度 ... 27.9 mm (1.10 in)
- 测试力 ... 125 至 145 N (28 至 33 lb)
- 测试后的自由长度 ... 42.7 mm (1.68 in)
- 外径 ... 17.3 mm (0.68 in)
- 测试力 ... 125 至 145 N (28 至 33 lb)
Caterpillar Information System:
Wiring Harness Recommendations For 3500B Locomotive Engines{1408} Wiring Harness Recommendations For 3500B Locomotive Engines{1408}
3412E, C30 and C32 Marine Engines Fuel Filter and Water Separator - Remove and Install
3054 and 3056 Industrial and Generator Set Engines Air Inlet and Exhaust System
G3500 Engines Turbocharger - Remove
3034 Engine for Caterpillar Built Machines Fuel Injection Lines - Remove and Install
3408E and 3412E Engines for Caterpillar Built Machines Aftercooler - Install
3176B Marine Engine Sensors and Electrical Components
3176B Industrial Engine Refill Capacities
3412E, C30 and C32 Marine Engines Engine Control Module - Remove and Install
3408E and 3412E Engines for Caterpillar Built Machines Aftercooler - Remove
3126B Marine Engine General Information
3126B Marine Engine Engine Design
365B Excavator Hydraulic System Oil (If Equipped with Fine Filtration Filter) - Change
3406E On-Highway Engine Camshaft Gear - Remove and Install
3412E, C30 and C32 Marine Engines Jacket Water Heater - Remove and Install
G3500 Engines Aftercooler - Remove and Install
3612 and 3616 Engines Engine Oil Pump
3612 and 3616 Engines Engine Oil Pump
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Unit Injector
3612 and 3616 Engines Engine Oil Pump
3034 Engine for Caterpillar Built Machines Fuel Transfer Pump - Remove
3034 Engine for Caterpillar Built Machines Fuel Transfer Pump - Install
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Unit Injector Mechanism
3034 Engine for Caterpillar Built Machines Inlet Manifold - Remove