Fuel Transfer Pump - Install
Installation Procedure
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Clean the mating surfaces of the fuel transfer pump and the cylinder block.
- Inspect the condition of the gasket. Replace the gasket, if necessary.
Show/hide table
 | |
| Illustration 1 | g00807902 |
Typical example | |
Note: Ensure that the camshaft lobe for the fuel transfer pump is at minimum lobe lift before the fuel transfer pump is installed.
- Put the gasket and fuel transfer pump (4) in position on the engine. Make sure that the rocker lever is positioned correctly on the camshaft lobe.
- Install four bolts (5) and evenly tighten the bolts to a torque of 22 N·m (16 lb ft).
- Connect fuel line (2) and fuel line (3) to the fuel transfer pump (1) .
Show/hide table
 | |
| Illustration 2 | g00720162 |
Typical example | |
- Prime the fuel system. Refer to the Testing and Adjusting Module, "Fuel System" topic for more information.
Caterpillar Information System:
3034 Engine for Caterpillar Built Machines Fuel Transfer Pump - Remove
3612 and 3616 Engines Engine Oil Pump
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Unit Injector
3612 and 3616 Engines Engine Oil Pump
3612 and 3616 Engines Engine Oil Pump
G3500 Engines Aftercooler - Remove and Install
3412E, C30 and C32 Marine Engines Jacket Water Heater - Remove and Install
3406E On-Highway Engine Camshaft Gear - Remove and Install
365B Excavator Hydraulic System Oil (If Equipped with Fine Filtration Filter) - Change
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Fuel Filter (Primary)
Wiring Harness Recommendations For 3500B Locomotive Engines{1408} Wiring Harness Recommendations For 3500B Locomotive Engines{1408}
3412E, C30 and C32 Marine Engines Fuel Filter and Water Separator - Remove and Install
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Unit Injector Mechanism
3034 Engine for Caterpillar Built Machines Inlet Manifold - Remove
3408E and 3412E Engines for Caterpillar Built Machines Piston Cooling Jets - Remove and Install
Installation And Mounting System For Locomotive Engine/Generator Packages{1021} Installation And Mounting System For Locomotive Engine/Generator Packages{1021}
CIPI UNDERCARRIAGE Arrangements: 1667049, 2372904, 3Q6481, 6Z7988, 6Z7989, 9Q5032, 9Q5040, 9Q5043, 9Q5046, 9Q5047, 9Q5066, 9Q5074, 9Q5097, 9Q5098, 9Q5116, 9Q5134, 9Q5136, 9Q5142, 9Q5147, 9Q5148, 9Q5149, 9Q5172 and 9Q5204 Front Idler
3034 Engine for Caterpillar Built Machines Inlet Manifold - Install
3600 Diesel Marine Monitoring System Fire Prevention and Explosion Prevention
3600 Diesel Marine Monitoring System General Hazard Information
3600 Diesel Marine Monitoring System Mounting and Dismounting
P16, P20, P25, P28, P40 and P60 Pulverizers Rotary Manifold - Disassemble
EMCPII+ for Gas Engines Service Record
3176C and 3196 Engines for Caterpillar Built Machines Engine Oil Pressure - Test