Inlet Manifold - Remove
Removal Procedure
Start By:
- Remove the fuel injection lines. Refer to Disassembly and Assembly, "Fuel Injection Lines - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove eight bolts (1) from air inlet manifold (2) .
Show/hide table
Illustration 1 | g00580923 |
- Remove air inlet manifold (2) and gasket (3) from the engine. Check the condition of gasket (3). If gasket (3) is worn or damaged, use a new part for replacement.
Show/hide table
Illustration 2 | g00580932 |
Caterpillar Information System:
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Unit Injector Mechanism
3034 Engine for Caterpillar Built Machines Fuel Transfer Pump - Install
3034 Engine for Caterpillar Built Machines Fuel Transfer Pump - Remove
3612 and 3616 Engines Engine Oil Pump
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Unit Injector
3612 and 3616 Engines Engine Oil Pump
3612 and 3616 Engines Engine Oil Pump
G3500 Engines Aftercooler - Remove and Install
3412E, C30 and C32 Marine Engines Jacket Water Heater - Remove and Install
3406E On-Highway Engine Camshaft Gear - Remove and Install
365B Excavator Hydraulic System Oil (If Equipped with Fine Filtration Filter) - Change
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Fuel Filter (Primary)
3408E and 3412E Engines for Caterpillar Built Machines Piston Cooling Jets - Remove and Install
Installation And Mounting System For Locomotive Engine/Generator Packages{1021} Installation And Mounting System For Locomotive Engine/Generator Packages{1021}
CIPI UNDERCARRIAGE Arrangements: 1667049, 2372904, 3Q6481, 6Z7988, 6Z7989, 9Q5032, 9Q5040, 9Q5043, 9Q5046, 9Q5047, 9Q5066, 9Q5074, 9Q5097, 9Q5098, 9Q5116, 9Q5134, 9Q5136, 9Q5142, 9Q5147, 9Q5148, 9Q5149, 9Q5172 and 9Q5204 Front Idler
3034 Engine for Caterpillar Built Machines Inlet Manifold - Install
3600 Diesel Marine Monitoring System Fire Prevention and Explosion Prevention
3600 Diesel Marine Monitoring System General Hazard Information
3600 Diesel Marine Monitoring System Mounting and Dismounting
P16, P20, P25, P28, P40 and P60 Pulverizers Rotary Manifold - Disassemble
EMCPII+ for Gas Engines Service Record
3176C and 3196 Engines for Caterpillar Built Machines Engine Oil Pressure - Test
EMCPII+ for Gas Engines AC Factory Calibration Setpoint Viewing OP2-2
EMCPII+ for Gas Engines AC Offset Adjustment OP10