Fuel Control
Show/hide table
Illustration 1 | g00471185 |
(1) Actuator
(2) Actuator shaft
(3) Lever
(4) Actuator indicator
(5) Rod and rod ends
(6) Clevis
(7) Fuel valve
(8) Tighten the four mounting bolts to the following torque. ... 28 ± 7 N·m (21 ± 5 lb ft)
Adjust the fuel linkage as follows.
- Set the fuel valve (7) to the closed position. Push the stem into the valve.
- Rotate the actuator shaft (2) until the actuator is in the closed position (0 percent).
- Assemble the lever (3) to the actuator shaft at 90 degrees from vertical as shown.
- Adjust the rod and the rod ends (5) to a length of 120 mm (4.7 inch). Provide equal thread engagement on the rod.
- Attach the rod to the lever (3) and the clevis (6) .
- Hold the fuel valve and the actuator shaft in the fully closed position. Rotate the clevis until the actuator indicator (4) is 2.0 ± .5 degrees from the zero position (closed).
- Tighten the stop nuts to contact the clevis and the rod ends.
Note: The actuator indicator is calibrated to show the percentage NOT THE ANGLE that the fuel valve is open or closed. 2 degrees is equal to approximately 5 percent.
Caterpillar Information System:
3306C Truck Engine Turbocharger - Remove
3304B and 3306B Engines for Caterpillar Built Machines Compression Brake - Assemble
G3612 and G3616 Engines Flexible Drive
3304B and 3306B Engines for Caterpillar Built Machines Compression Brake - Disassemble
G3606 and G3608 Engines Flexible Coupling
3304B and 3306B Engines for Caterpillar Built Machines Compression Brake - Install
3304B and 3306B Engines for Caterpillar Built Machines Compression Brake - Remove
3306B Industrial Engine Engine Oil Cooler - Install
3304B and 3306B Engines for Caterpillar Built Machines Engine Oil Cooler - Assemble
3304B and 3306B Engines for Caterpillar Built Machines Engine Oil Cooler - Disassemble
G3606 and G3608 Engines Gas Engine Ignition
G3606 and G3608 Engines Fuel Lines
3406E, C-10 and C-12 Truck Engines Belt - Inspect
G3612 and G3616 Engines Pressure Switch
3306C Truck Engine Turbocharger - Install
G3606 and G3608 Engines Exhaust Bypass Valve
3306C Truck Engine Turbocharger - Disassemble
3306C Truck Engine Turbocharger - Assemble
G3606 and G3608 Engines Air Lines
3406E, C-10, C-12, C-15, C-16 Truck Engines Engine Oil Level - Check
3406E, C-10, C-12, C-15, C-16 Truck Engines Cylinder Head Grounding Stud - Inspect/Clean/Tighten
3406E, C-10, C-12, C-15, C-16 Truck Engines Engine Oil Level Gauge - Calibrate - C-10 and C-12 Engines Only
G3612 and G3616 Engines Engine Design
3306C Truck Engine Turbocharger Wastegate - Remove and Install