Turbocharger - Disassemble
Disassembly Procedure
Show/hide table
Required Tools     | |||
---|---|---|---|
Tool     | Part Number     | Part Description     | Qty     |
A     | 1P-1853     | Retaining Ring Pliers     | 1     |
Start By:
- Remove the turbocharger. Refer to Disassembly and Assembly, "Turbocharger - Remove" .
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Put an alignment mark on the three casings of the turbocharger for correct alignment during assembly.
Show/hide table
Illustration 1 | g00471438 |
- Loosen clamp (2) . Remove compressor housing (1) and clamp (2) from turbine housing (3) .
- Loosen clamp (5) . Remove cartridge assembly (4) and clamp (5) from turbine housing (3) .
Show/hide table
Illustration 2 | g00471439 |
Caterpillar Information System:
G3606 and G3608 Engines Exhaust Bypass Valve
3306C Truck Engine Turbocharger - Install
G3612 and G3616 Engines Pressure Switch
3406E, C-10 and C-12 Truck Engines Belt - Inspect
G3606 and G3608 Engines Fuel Control
3306C Truck Engine Turbocharger - Remove
3304B and 3306B Engines for Caterpillar Built Machines Compression Brake - Assemble
G3612 and G3616 Engines Flexible Drive
3304B and 3306B Engines for Caterpillar Built Machines Compression Brake - Disassemble
G3606 and G3608 Engines Flexible Coupling
3304B and 3306B Engines for Caterpillar Built Machines Compression Brake - Install
3304B and 3306B Engines for Caterpillar Built Machines Compression Brake - Remove
3306C Truck Engine Turbocharger - Assemble
G3606 and G3608 Engines Air Lines
3406E, C-10, C-12, C-15, C-16 Truck Engines Engine Oil Level - Check
3406E, C-10, C-12, C-15, C-16 Truck Engines Cylinder Head Grounding Stud - Inspect/Clean/Tighten
3406E, C-10, C-12, C-15, C-16 Truck Engines Engine Oil Level Gauge - Calibrate - C-10 and C-12 Engines Only
G3612 and G3616 Engines Engine Design
3306C Truck Engine Turbocharger Wastegate - Remove and Install
G3612 and G3616 Engines Engine Design
3406E, C-10 and C-12 Truck Engines Belt Tensioner - Inspect
3306C Truck Engine Exhaust Manifold - Remove and Install
3306C Truck Engine Water Temperature Regulator - Remove and Install
3406E, C-10, C-12, C-15, C-16 Truck Engines Engine Oil and Filter - Change