C15 and C18 Engines for Caterpillar Built Machines Caterpillar


Flywheel Housing

Usage:

826K 2L3


图 1g03512056

表 1
275-4185 飞轮壳总成的技术规格 
项目  数量  零件  技术规格说明 
在安装飞轮壳前,检查下列部件上有无任何异物:飞轮壳的前端面、飞轮壳垫片两侧和缸体的后端面。 这些部件上必须没有以下物质:机油、燃油、水、垫片粘合剂、装配固定胶和任何其他异物。 涂覆超蓝 Loctite 587 以便密封发动机油底壳、缸体和飞轮壳之间的接合处。 
223-4903 螺栓  按照以下步骤拧紧飞轮壳螺栓:

1.按照图 1 中所示的数字顺序将螺栓 1 至 9 拧紧至扭矩为 100 ± 20 N·m (75 ± 15 lb ft)
2. 按照图 1 中所示的数字顺序将螺栓 10 至 23 拧紧至扭矩为 40 ± 10 N·m (30 ± 7 lb ft)
3. 再次按照图 1 中所示的数字顺序将螺栓 1 至 9 拧紧至扭矩为 135 ± 20 N·m (100 ± 15 lb ft)
4. 再次按照图 1 中所示的数字顺序将螺栓 10 至 23 拧紧至扭矩为 55 ± 10 N·m (41 ± 7 lb ft)。 
165-3932 螺栓 
5J-5793 螺栓 
165-3930 螺栓 
5J-5794 螺栓 

Caterpillar Information System:

C13, C15, and C18 Tier 4 Final Engines Crankshaft
C15 and C18 Engines for Caterpillar Built Machines Electronic Unit Injector Mechanism
C13, C15, and C18 Tier 4 Final Engines Water Pump
C15 and C18 Engines for Caterpillar Built Machines Electronic Unit Injector Mechanism
Cat MT4400D AC Off-Highway Truck VIMSTM 3G and Truck Payload Measurement System (TPMS) Payload Configure
2014/06/27 New VIMS ABL Software Is Now Used On Certain Off-Highway Trucks {7601, 7620}
2013/11/08 An Improved Commissioning Procedure is now Available for the 797F Off-Highway Truck {1000, 7000, 7961}
434-6509 Water Ferrule Pressure Tool{0374, 0599, 0701, 0703, 1100} 434-6509 Water Ferrule Pressure Tool{0374, 0599, 0701, 0703, 1100}
24 Motor Graders Liquid Level Sensor
14L Motor Grader Electronic Control (Aftertreatment) - Remove and Install
836K Landfill Compactor, 834K Wheel Dozer and 988K Wheel Loader Power Train Modulating Valve (Transmission Clutch) - Remove and Install
730C and 730C2 EJECTOR Articulated Truck Systems Ejector Control Valve
C13, C15, and C18 Tier 4 Final Engines Flywheel Housing Cover
C13, C15, and C18 Tier 4 Final Engines Gear Group (Rear)
C4.4 Industrial Engine Stopping the Engine
725C, 725C2, 730C, 730C2 and 730C, 730C2 EJECTOR Articulated Truck Systems Drive Shaft
725C, 725C2, 730C and 730C2 Articulated Truck Systems Calibrations (Cat ET)
2013/12/09 An Improved Routing Process is Now Available When Replacing 192-7805 Harness As in TLV1 Seat Suspensions on Certain Machines {1408, 7312, 7324}
C4.4 Engines for Caterpillar Built Machines Gear Group (Front)
C13, C15, and C18 Tier 4 Final Engines Gear Group (Front)
Cat ® Fleet Onboard Software Version 3.1 Locks Up{7605} Cat ® Fleet Onboard Software Version 3.1 Locks Up{7605}
994K Wheel Loader Service Center
C4.4 and C7.1 Engines Fuel Pressure Problem
14L Motor Grader Battery - Remove and Install
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.