C4.4 and C7.1 Engines Caterpillar


Fuel Pressure Problem

Usage:

525D 2L5
要故障排除低压燃油系统中的异常压力,或下述任意故障诊断代码激活,使用此步骤。 请参阅故障诊断与排除, "故障诊断代码"以了解有关代码的信息。

表 1
故障诊断代码 
CDL 代码  代码说明  注释 
E198(1)  低燃油压力:级别 1  燃油细滤器出口压力传感器上的燃油压力小于 190 kPa (27.5 psi)
无 E390 或 E1129 事件代码激活。
记录该代码。 
E390(1)  燃油滤清器阻塞:级别 1  燃油细滤器部分阻塞。
无 289 或 460 代码激活。
记录该代码。 
E390(2)  燃油滤清器阻塞:级别 2  燃油细滤器阻塞。
无 289 或 460 代码激活。
记录该代码。
发动机功率减额。 
E1129(1)  燃油滤清器(吸油侧)阻塞:级别 1  燃油粗滤器部分阻塞。
无 2247 代码激活。
记录该代码。 
E1129(2)  低燃油油轨压力:级别 2  燃油粗滤器阻塞。
无 2247 代码激活。
记录该代码。
发动机功率减额。 

可能原因

  • 低压燃油管阻塞

  • 燃油粗滤器或细滤器阻塞

建议的措施

注: 下面以概率的先后顺序列出了这些步骤。 依次完成这些步骤。

表 2
故障诊断与排除测试步骤  数值  结果 

1. 检查燃油管有无阻塞

A. 如有配备,确保燃油隔离阀完全开启。

B. 检查燃油箱和高压燃油泵之间的所有燃油管有无阻塞或损坏。
 

阻塞
 

结果:燃油隔离阀未完全开启。

修理:将燃油隔离阀移到全开位置。

使用电子维修工具,检查有无任何事件代码不再激活。

结果:燃油管存在阻塞。

修理:清除阻塞或更换燃油管。

使用电子维修工具,检查有无任何事件代码不再激活。

结果:燃油隔离阀完全开启,燃油管没有阻塞。

转至测试步骤 2。
 

2. 检查有无激活的事件代码

A. 使用电子维修工具检查表 1 中所列的事件代码。
 

事件代码
 

结果:事件代码 E1129-X 激活。

修理:更换燃油粗滤器滤芯。 请参阅操作和保养手册以了解更多信息。

结果:事件代码 E390-X 激活。

更换燃油细滤器滤芯。 请参阅操作和保养手册以了解更多信息。

结果:事件代码 E198-1 激活。

更换高压燃油泵。 请参阅拆解和装配, "喷油泵 - 拆卸"和拆解和装配, "喷油泵 - 安装"。

如果该步骤无法排除故障,请联系代理商解决方案网络 (DSN)。
 

Caterpillar Information System:

994K Wheel Loader Service Center
Cat ® Fleet Onboard Software Version 3.1 Locks Up{7605} Cat ® Fleet Onboard Software Version 3.1 Locks Up{7605}
C13, C15, and C18 Tier 4 Final Engines Gear Group (Front)
C4.4 Engines for Caterpillar Built Machines Gear Group (Front)
2013/12/09 An Improved Routing Process is Now Available When Replacing 192-7805 Harness As in TLV1 Seat Suspensions on Certain Machines {1408, 7312, 7324}
725C, 725C2, 730C and 730C2 Articulated Truck Systems Calibrations (Cat ET)
725C, 725C2, 730C, 730C2 and 730C, 730C2 EJECTOR Articulated Truck Systems Drive Shaft
C4.4 Industrial Engine Stopping the Engine
C13, C15, and C18 Tier 4 Final Engines Gear Group (Rear)
C13, C15, and C18 Tier 4 Final Engines Flywheel Housing Cover
C15 and C18 Engines for Caterpillar Built Machines Flywheel Housing
C13, C15, and C18 Tier 4 Final Engines Crankshaft
14L Motor Grader Battery - Remove and Install
C4.4 Engines for Caterpillar Built Machines Fuel Filter Base - Twin Secondary Fuel Filter Base
C4.4 Engines for Caterpillar Built Machines Fuel Injection Pump
C4.4 Engines for Caterpillar Built Machines Turbocharger
14L Motor Grader Diesel Particulate Filter - Remove and Install
730C2 Articulated Truck Cooling System Water Temperature Regulator - Replace
730C and 730C2 EJECTOR Articulated Truck Systems Ejector Circuit
730C EJECTOR Articulated Truck Service Brake Control
730C EJECTOR Articulated Truck Engine Compression Brake Control
836K Landfill Compactor, 834K Wheel Dozer and 988K Wheel Loader Power Train Power Train Oil Filter Bypass Valve - Remove and Install
Rear Final Drive Brake and Wheel Group Assembly and Disassembly System{0374, 0599, 0700, 0727, 0730, 0731} Rear Final Drive Brake and Wheel Group Assembly and Disassembly System{0374, 0599, 0700, 0727, 0730, 0731}
24 Motor Grader Engine Crankcase Breather - Clean
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.