Illustration 1 | g03064342 |
Tool buttons |
The tool button display expands vertical and buttons stack. The tool button display would allow for four buttons. A dedicated button at the bottom is available to scroll to other tool buttons.
The following functions are accessible from the tool bar windows:
- Operator login
- Send a mayday
- Mark hazards
- Diagnostics
- Switch toolbars
- Delays
- Zone lock
- Data record
Illustration 2 | g03410764 |
Operator login - This toolbar button is used to change the operator.
Illustration 3 | g03106256 |
Send mayday - This toolbar button is used to send a mayday to the office.
The mayday feature is for non-critical situations where the operator requires assistance from office personnel. Due to the nature of wireless communications, the mayday message is not ensured to reach the office in a timely manner. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility. Use other methods of communication for safety critical situations. |
Illustration 4 | g03416726 |
Mark hazard - This toolbar button is used to mark a hazard.
Illustration 5 | g03142760 |
Switch toolbars - This toolbar button is used to cycle through the toolbars on the display.
Illustration 6 | g03411582 |
Delay (Command for Hauling only) - This toolbar button is used to enter a delay.
Illustration 7 | g03385121 |
Delay list pop-up window |
Perform the following procedure:
- Press the delay icon on the tool bar window. A pop-up screen displays.
- Select a reason for the delay.
- Use the double arrow buttons to increase or decrease the anticipated duration of the delay.
Note: The user may select the "Buzzer" option to be alerted when the predicted time for the delay has ended.
- Press "OK" to send the message to the command center.
Illustration 8 | g03037416 |
Zone lock (Command for Hauling only) - This toolbar button is used to lock a predefined zone.
Illustration 9 | g03037296 |
Collect and Send Position Data(Command for Hauling only) - This toolbar button is used to collect survey data from the on-board GPS receiver.