Upper Conveyor Deflectors (Second Stage) - Inspect/Replace
- Remove the secondary conveyor upper covers (1) .
Show/hide table
 | |
| Illustration 1 | g03434027 |
- Inspect the deflectors for wear parts. Adjust the deflectors or replace the deflectors as required. During normal operations, the deflectors must be registered so to slightly touch the secondary conveyor belt. Adjusting the deflectors will help avoid loss of material from both sides of the secondary conveyor.
- Loosen screws (2) and adjust the distance of the deflectors from the secondary conveyor belt. The deflectors have just to touch the surface of the secondary conveyor belt.
Show/hide table
Illustration 3 g03434041
- Remove screws (2) and plate (3) to remove the deflector (4). Perform this procedure on all deflectors that must be changed along the secondary conveyor. Proceed in the reverse steps to install a new deflector on the secondary conveyor.
Show/hide table
Illustration 4 g03434062
Show/hide table
 | |
| Illustration 2 | g03434033 |
Caterpillar Information System:
PM-200 Cold Planer Steering Cylinder Ends - Lubricate
PM-200 Cold Planer Steering Linkage - Lubricate
Cat® Detect Proximity Awareness Onboard System Proximity Alarming
2013/09/24 A New Ether Cylinder O-ring is Now Used on All Caterpillar Products {1456}
Cat® Detect Proximity Awareness Onboard System Tool Button Display
14L Motor Grader Machine Systems Bank Valve - Install - Rear Frame
14L Motor Grader Machine Systems Bank Valve - Disassemble - Rear Frame
14L Motor Grader Machine Systems Bank Valve - Assemble - Rear Frame
PM-200 Cold Planer Track Drive Planetary Oil - Change
PM-200 Cold Planer Track Drive Planetary Oil Level - Check
834K Wheel Dozer and 836K Landfill Compactor TA2 Technical Inspection {0372, 1000, 7000, 753T, 7565} 834K Wheel Dozer and 836K Landfill Compactor TA2 Technical Inspection {0372, 1000, 7000, 753T, 7565}
PM-200 Cold Planer Track Shoe Bolts - Tighten
988K XE Wheel Loader Machine Systems Ride Control Valve - Assemble
AS4173 Asphalt Screed Machine Systems Tamper Bar - Check and Adjust
2014/02/12 New Installation Kits are now Available for Cat® MineStar Fleet Onboard and Cat® MineStar Health Systems {7605}
2013/12/06 New Exhaust Shield Now Used on Certain R1700G Load Haul Dump Machines {1067}
2013/09/20 New Procedure to Flash LADAR Firmware Now Used on MINEGEM Equipped Machines {7600, 7615}
PM-200 Cold Planer Engine Oil and Filter - Change
966M Series XE and 972M Series XE Wheel Loaders Plate Locations and Film Locations
PM-200 Cold Planer Engine Oil Level - Check
PL83 and PL87 Pipelayers Engine Supplement Fuel Filter Base and Priming Pump - Remove and Install
PM-200 Cold Planer Engine Oil Sample - Obtain
C7.1 Industrial Engine Turbocharger Exhaust Temperature Sensor
2013/10/09 Front Suspension Group Has Been Improved on Certain Off-Highway Trucks {7201}