Water Pump - Install
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
|
Water pumps may leak as a result of damaged face seals. Relative movement between the shaft and the housing may allow the drive shaft to contact the face seal in the water pump. If contact occurs, the face seal will be damaged, and very early hour failures can result. |
- Refer to Special Instruction , REHS9244 for proper water pump handling procedures prior to installation.
Show/hide table
Illustration 1 g01460744 - Attach a suitable lifting device onto water pump (1). The weight of water pump (1) is approximately
27 kg (60 lb) . Position water pump (1) onto the engine. Install bolts (7). - Install bolts (5).
- Position elbow (6) and install bolts (8).
- Inspect the O-ring seal for tube assembly (2). Obtain a new O-ring seal, if necessary. Lubricate the bore of elbow (6) lightly with glycerin. Insert the O-ring seal into the bore of elbow (6). Insert tube assembly (2) into the bore of elbow (6).
- Install clamp assembly (4) and bolts (3).
- Fill the cooling system with coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
Caterpillar Information System:
3500B Engines and 776D, 777D, 784C, 785C, 789C, 793C and 793D Off-Highway Truck/Tractors Crankcase Breather
C13, C15, and C18 Generator Set Engines Camshaft
3512C Engine for Caterpillar Built Machines Water Pump - Remove
3512C Engine for Caterpillar Built Machines Water Temperature Regulators - Install
966H Wheel Loader and 972H Wheel Loader Power Train MID 081 - CID 0621 - FMI 03
2008/02/25 New Software For the Machine ECM Is Now Available {7620}
511 Track Feller Buncher, 521 Track Feller Buncher, 522 Track Feller Buncher and 532 Track Feller Buncher Machine Systems Piston Pump (Main Hydraulic)
3512C Engine for Caterpillar Built Machines Water Temperature Regulators - Remove
Replacement of the Cab Roof on Certain Caterpillar Machines {7301} Replacement of the Cab Roof on Certain Caterpillar Machines {7301}
C4.4 Engines For Caterpillar Built Machines Start Relay Circuit - Test
24M Motor Grader Machine Systems Fuel Tank - Install
24M Motor Grader Machine Systems Fuel Tank - Remove
2008/06/23 Changes to Operation and Maintenance , "Track (Rubber) - Inspect/Adjust" {4197, 4198}
A False Diagnostic Code is Generated When Flashing Software in Some Excavators{1901, 1902, 7600, 7610, 7620} A False Diagnostic Code is Generated When Flashing Software in Some Excavators{1901, 1902, 7600, 7610, 7620}
120K Motor Grader Safety Messages
2008/03/03 Caterpillar Machine Control and Guidance Repair Center {7220, 7604}
120K Motor Grader Additional Messages
3512C Engine for Caterpillar Built Machines Auxiliary Water Pump - Remove
2008/03/17 The Procedure to Mount the Rear Axle is Updated {3260, 3278, 3282, 4068}
2008/04/28 An Improved Refrigerant Compressor Gp Is Available {1802}
2008/03/31 Increased Filtration of the Power Train is Now Available {3067}
2008/05/12 An Improved Muffler is Available for Motor Graders {1062, 1062}
AP-1000D and BG-260D Asphalt Pavers Propel System Final Drive
2008/07/21 New Radiator Header Tank Hosing is Now Used {1353}