Drive Shaft (Crown) - Disassemble
Disassembly Procedure
Start By:
- Remove the drive shaft (crown). Refer to Disassembly and Assembly, "Drive Shaft (Crown) - Remove".
- Remove bearing (1) from threaded rod (2) .
Show/hide table
Illustration 1 | g01280172 |
- Remove roll pin (3) from shaft assembly (4) .
- Remove threaded rod (2) from shaft assembly (4) .
- Remove bearing assembly (5) from spindle assembly (6) and shaft assembly (4) .
Caterpillar Information System:
AS2302 Vers-A-Mat Screed Drive Shaft (Crown) - Remove
2006/07/24 Improved Pin for the Transport Lock Is Used {6203, 7505}
2006/06/26 The Addition of Spacer Plates Avoids Contact Between Ejector Frames and End Plates {6203, 7271}
C4.4 Industrial Engine Engine Oil Pressure - Test
2006/06/26 New Pilot Line for the Hoist Control Valve Is Available {5136}
2006/06/26 A New Lens for the Rear Signal Lamp Is Available {1430}
R1700G Load Haul Dump Battery Isolation Control - If Equipped
R1700G Load Haul Dump Steering System Steering Cylinder Mounting
572R Series II Pipelayer Operator Controls
2006/07/24 A New Speed-Timing Sensor is Now Available {1912}
Bench Test Procedure For A MT835, MT845, MT855, MT865, MTC835, MTC845, MTC855, and MTC865 Agricultural Tractor Transmission {3030, 3073} Bench Test Procedure For A MT835, MT845, MT855, MT865, MTC835, MTC845, MTC855, and MTC865 Agricultural Tractor Transmission {3030, 3073}
416E, 422E and 428E Backhoe Loaders Hydraulic and Steering System Hydraulic Lockout Function
AS2302 Vers-A-Mat Screed Drive Shaft (Crown) - Assemble
AS2302 Vers-A-Mat Screed Drive Shaft (Crown) - Install
D-Series and D2-Series Compact Track Loaders (CTL), Multi-Terrain Loaders (MTL), and Skid Steer Loaders (SSL) Work Tool - Lubricate
HF181, HF201 and HF221 Felling Heads Tilt Group (Full)
C7 Engine for the AP-755 Asphalt Paver and the PM-102 Cold Planer ECM Will Not Communicate with Other Systems or Display Modules
AS2302 Vers-A-Mat Screed Solenoid Valve (Extender Extend and Extender Slope) - Assemble
AS2302 Vers-A-Mat Screed Solenoid Valve (Extender Extend and Extender Slope) - Disassemble
3176C Engines for Caterpillar Built Machines Electrical Power Supply Circuit - Test
THP10 Series II and THP24S Series II Access Platform for Series B Telehandlers Check Valve - Remove and Install
246C, 256C, 262C and 272C Skid Steer Loaders Hydraulic Tank Breather - Replace
770 and 772 Off-Highway Truck Hydraulic and Braking System Parking and Secondary Brake Release System Leakage - Check
3176C Engines for Caterpillar Built Machines Throttle Switch Circuit - Test