Steering Cylinder Mounting
Show/hide table
 | |
| Illustration 1 | g01280112 |
(1) Torque for the two nuts ... 500 ± 65 N·m (370 ± 48 lb ft)
(2) Apply Loctite C5-A to the inside diameters and to the outside diameters of all collets prior to assembly.
(3) Apply Loctite 609 to the seal grooves prior to seal installation.
(4) Apply Cat Advanced 3 Moly Grease to the pin bores prior to assembly.
(5) Apply Loctite C5-A to the threads of the bolts prior to assembly.
- Torque for the two bolts ... 900 ± 100 N·m (660 ± 75 lb ft)
Caterpillar Information System:
572R Series II Pipelayer Operator Controls
2006/07/24 A New Speed-Timing Sensor is Now Available {1912}
Bench Test Procedure For A MT835, MT845, MT855, MT865, MTC835, MTC845, MTC855, and MTC865 Agricultural Tractor Transmission {3030, 3073} Bench Test Procedure For A MT835, MT845, MT855, MT865, MTC835, MTC845, MTC855, and MTC865 Agricultural Tractor Transmission {3030, 3073}
416E, 422E and 428E Backhoe Loaders Hydraulic and Steering System Hydraulic Lockout Function
AS2302 Vers-A-Mat Screed Screed Chain (Crown) - Remove and Install
THP10 Series II and THP24S Series II Access Platform for Series B Telehandlers Rotary Actuator - Remove and Install
Metal Shavings in the Hydraulic Electronic Unit Injector (HEUI) Oil Passages{1250, 1274} Metal Shavings in the Hydraulic Electronic Unit Injector (HEUI) Oil Passages{1250, 1274}
AS2302 Vers-A-Mat Screed Shoe (End Gate) - Remove and Install
AS2302 Vers-A-Mat Screed Actuator (End Gate) - Remove and Install
14M and 16M Motor Graders Machine Systems Battery
14M and 16M Motor Graders Machine Systems Battery
Installation of a New Hydraulic Pump and a New Suction Hose Can Improve Service Life of Certain Telehandlers{5057, 5070} Installation of a New Hydraulic Pump and a New Suction Hose Can Improve Service Life of Certain Telehandlers{5057, 5070}
R1700G Load Haul Dump Battery Isolation Control - If Equipped
2006/06/26 A New Lens for the Rear Signal Lamp Is Available {1430}
2006/06/26 New Pilot Line for the Hoist Control Valve Is Available {5136}
C4.4 Industrial Engine Engine Oil Pressure - Test
2006/06/26 The Addition of Spacer Plates Avoids Contact Between Ejector Frames and End Plates {6203, 7271}
2006/07/24 Improved Pin for the Transport Lock Is Used {6203, 7505}
AS2302 Vers-A-Mat Screed Drive Shaft (Crown) - Remove
AS2302 Vers-A-Mat Screed Drive Shaft (Crown) - Disassemble
AS2302 Vers-A-Mat Screed Drive Shaft (Crown) - Assemble
AS2302 Vers-A-Mat Screed Drive Shaft (Crown) - Install
D-Series and D2-Series Compact Track Loaders (CTL), Multi-Terrain Loaders (MTL), and Skid Steer Loaders (SSL) Work Tool - Lubricate
HF181, HF201 and HF221 Felling Heads Tilt Group (Full)