Disassembly Procedure
Start By:
- Remove the solenoid valve. Refer to Disassembly and Assembly, "Solenoid Valve (Extender Extend) - Remove".
- Remove the solenoid valve. Refer to Disassembly and Assembly, "Solenoid Valve (Extender Slope) - Remove".
Note: Cleanliness is an important factor. Before you begin the disassembly procedure, the exterior of the components should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism. Precision components can be damaged by contaminants or by dirt. Perform disassembly procedures on a clean work surface. Keep components covered and protected at all times.
- Remove bolts (2) and valve block (1) .
 | |
| Illustration 1 | g01280373 |
- Remove plugs (3), O-ring seals (4), pins (5), springs (6), check balls (7), caps (8), and valve (9) from valve block (1) .
 | |
| Illustration 2 | g01280371 |
 |
Personal injury can result from being struck by parts propelled by a released spring force. Make sure to wear all necessary protective equipment. Follow the recommended procedure and use all recommended tooling to release the spring force. |
 |
- Remove O-ring seals (10) from valve body (11) .
 | |
| Illustration 3 | g01280369 |
- Remove bolts (13), end plate (14), and solenoid (12) .
 | |
| Illustration 4 | g01280367 |
- Remove sleeve (17), spring (16), and sleeve (15) .
 | |
| Illustration 5 | g01280366 |
|
Personal injury can result from being struck by parts propelled by a released spring force. Make sure to wear all necessary protective equipment. Follow the recommended procedure and use all recommended tooling to release the spring force. |
|
- Remove spool (18) from valve body (11) .
- Remove O-ring seal (19) from spool (18) .
 | |
| Illustration 6 | g01280365 |
- Remove spring (23) and spring seat (22) from valve body (11) .
 | |
| Illustration 7 | g01280364 |
- Remove spool (21) from valve body (11) .
- Repeat Steps 4 through 8 in order to remove solenoid assembly (20) .