Modulating Valve (Transmission Hydraulic Control)
Show/hide table
图 1 | g01247676 |
SAE 30 机油在 1000 kPa (145.0 psi) 压降时的流量 ... 140 L/min (37.0 US gpm)
(1) 螺母的最后安装扭矩 ... 13 ± 1.5 N·m (115 ± 13 lb in)
(2) 323-9531 线圈
- 最小工作温度 ... −40 °C (−40.0
°F)
- 最大工作温度与最大输入电流 ... 121 °C (250.0 °F)
- 标称线圈电压 ... 24 VDC
- 25°C (77°F) 时的标称线圈电阻 ... 8.7 ± 0.4 欧姆
- 最大工作温度为 121 °C (250.0 °F) 时的最大输入电流 ... 1 安培
- 最大工作温度与最大输入电流 ... 121 °C (250.0 °F)
(3) 安装螺纹接头组件的扭矩 ... 14 ± 4 N·m (124 ± 35 lb in)
Show/hide table
图 2 | g01821014 |
A-A 视图 |
(4) 安装阀芯组件的扭矩 ... 50 ± 5 N·m (445 ± 45 lb in)
(5) 用少许密封的润滑剂润滑 O 形密封圈。
(6) 用少许密封的润滑剂润滑 O 形密封圈。
(7) 组装前,将 4C-9507 固定胶 涂抹到调整螺钉上。 安装调整螺钉的扭矩 ... 16 ± 2 N·m (140 ± 20 lb in)
(8) 118-3731 弹簧
- 在试验力下的长度 ... 14.00 mm (0.551
in)
- 试验力 ... 36.0 ± 1.8 N (8.10 ± 0.40 lb)
- 试验后的自由长度 ... 15.99 mm (0.630 in)
- 外径 ... 12.1 mm (0.48 in)
- 试验力 ... 36.0 ± 1.8 N (8.10 ± 0.40 lb)
Caterpillar Information System:
C7 Engines for Caterpillar Built Machines Vibration Damper
587R Pipelayer Hydraulic System Oil - Change
24M Motor Grader Machine Systems Lubrication Injectors - Check and Adjust
414E, 416E, 420E, 422E, 428E, 430E, 432E, 434E, 442E and 444E Backhoe Loaders Power Train Transmission (Power Shift) - Install
24M Motor Grader Braking and Hydraulic Fan System Piston Pump (Brake, Hydraulic Fan) Margin Pressure - Test and Adjust
C15 and C18 Generator Set Engines Engine - Install
C9.3 Engine for Caterpillar Built Machines Cylinder Head
Convert the Buckets from the J-Series Base Edge Assemblies to the K-Series Base Edge Assemblies{6523, 6803, 6805} Convert the Buckets from the J-Series Base Edge Assemblies to the K-Series Base Edge Assemblies{6523, 6803, 6805}
587T Pipelayer Fuses and Circuit Breakers - Replace/Reset
587R Pipelayer Fuel Tank Water and Sediment - Drain
Instructions for Installing a Felling Head Arrangement{6000, 6319} Instructions for Installing a Felling Head Arrangement{6000, 6319}
583T Pipelayer Machine Systems Main Control Valve - Install
572R Series 2, 583T, 587T, PL83 and PL87 Pipelayers Event Code List
587T Pipelayer Hydraulic System Oil Level - Check
120M, 12M, 140M, 14M, 160M and 16M Motor Graders Implement Electronic Control System MID 082 - CID 1471 - FMI 04
120M, 12M, 140M, 14M, 160M and 16M Motor Graders Implement Electronic Control System MID 082 - CID 1471 - FMI 08
C7 Engine for the AP-755 Asphalt Paver and the PM-102 Cold Planer CID 0267 FMI 02 Incorrect Engine Shutdown Switch inputs
120M, 12M, 140M, 14M, 160M and 16M Motor Graders Implement Electronic Control System MID 082 - CID 2150 - FMI 03
C7 Engine for the AP-755 Asphalt Paver and the PM-102 Cold Planer E363 High Fuel Supply Temperature
RM-300 Reclaimer Mixer Power Train Piston Motor (Front Propel) - Remove
RM-300 Reclaimer Mixer Power Train Piston Motor (Front Propel) - Install
R1300G Series II Load Haul Dump Machine Systems Solenoid Valve (Ride Control, Rod End) - Remove and Install
R1700G Load Haul Dump C11 Engine Supplement Radiator Tank (Header) - Remove
R1700G Load Haul Dump C11 Engine Supplement Radiator Tank (Header) - Install