Pistons and Connecting Rods - Remove
Show/hide table
所需工具 | |||
---|---|---|---|
工具 | 零件号 | 零件描述 | 数量 |
A | 5R-7425 | 盘车控制装置总成(1) | 1 |
B | 1P-1861 | 挡圈钳 | 1 |
C | 271-0498 | 涨圈 | 1 |
Show/hide table
(1) | 9S-9082 发动机转动工具是备用工具。 |
开始:
- 拆xia 缸盖。 请参阅拆解和组装, "缸盖 - 拆卸"。
- 拆下活塞冷却喷嘴。 请参阅拆解和组装, "活塞冷却喷嘴 - 拆卸和安装"。
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 用工具 (A)转动曲轴,直至可以拆下螺栓 (1)。
- 从缸套内表面顶部开始清除积碳凸起。
- 检查连杆和连杆盖上的识别标记是否正确。 连杆和连杆盖侧面应该有蚀刻的编号。 该编号应与气缸编号一致。 如有必要,标记连杆和连杆盖。
注: 请勿压印连杆组件。
- 拆下螺栓 (1) 和连杆轴承盖 (2)。 推动连杆直到活塞环脱出缸套。
- 将活塞和连杆从缸套中拆下。
注: 在拆卸活塞和连杆期间,小心不要损坏缸套或曲轴轴颈。
Show/hide table图 2 g01051820 - 使用工具 (B) 拆下固定活塞销 (4) 的挡圈。 拆卸活塞销 (4)。 从连杆 (5) 上拆卸活塞 (3)。
- 将轴承从连杆 (5)和连杆盖上拆下。
注: 如有必要,将活塞裙从活塞顶上分开。
Show/hide table图 3 g00913818 - 使用工具 (C) 从活塞 (3) 上拆卸活塞环 (6)。
Show/hide table
图 1 | g00913801 |
Caterpillar Information System:
TK741, TK751 and TK752 Track Feller Bunchers Engine Supplement Muffler - Remove and Install
TH580B Telehandler Machine Systems Quick Coupler - Install
Asphalt Pavers Burner Electronic Control System System Schematic
C7 Engines for Caterpillar Built Machines Water Pump - Assemble
C7 Engines for Caterpillar Built Machines Water Pump - Disassemble
TK741, TK751 and TK752 Track Feller Bunchers Engine Supplement Refrigerant Compressor - Remove and Install
TH580B Telehandler Machine Systems Quick Coupler - Remove
Asphalt Pavers Burner Electronic Control System CID 943 FMI F12
Asphalt Pavers Burner Electronic Control System CID 942 FMI F06
TH580B Telehandler Machine Systems Solenoid Valve (Frame Leveling) - Remove and Install
834H Wheel Dozer and 836H Landfill Compactor Steering System System Pressure - Release
Asphalt Pavers Burner Electronic Control System CID 942 FMI F05
3508C, 3512C and 3516C Marine Engines Pistons and Connecting Rods - Install
2004/12/06 Procedure for the Separation of the Wiring Harness {1451}
793D Off-Highway Truck Safety Messages
12M, 140M and 160M Motor Graders Braking and Hydraulic Fan System Gear Motor (Hydraulic Fan)
2004/12/13 Correction to Special Instruction, "Product Link PL102C System Installation" and Systems Operation, Testing and Adjust, "Product Link PL102C" {7602}
2004/12/20 New PC Service Tool Software Released for Cellular Based Product Link {7620}
2004/12/13 New VIMS Version 10.43 Class of Onboard Software {7601, 7620}
2004/12/13 Correction to Special Instruction, "Product Link PL102C System Installation" {7620}
2004/12/20 New Pressure Sensor Now Used for 797 and 797B {5574}
2004/12/20 New Engine Software Improves Sensor Reliability on Wheel Loaders {7620}
R2900G Load Haul Dump Radiator Core - Clean
R1300G Series II Load Haul Dump Fire Suppression System (Foam) - If Equipped