Valve Covers
Usage:
Remove & Install Valve Covers
1. Remove crankcase ventilator.
2. Remove bolts (2) and valve cover (1).
NOTE: The following steps are for installation of the valve covers.
3. Put the gasket and valve cover (1) in position on the cylinder head.
4. Install bolts (2).
5. Tighten the bolts to a torque of 14 ± 3 N·m (10 ± 2 lb ft)in the number sequence shown.
6. Connect the hose to the crankcase ventilator. Make sure the clamps are tightened to a torque of 2.3 ± 0.6 N·m (20.00 ± 5.00 lb in).
NOTE: For more detailed information regarding the valve covers, see the topic "Valve Covers" in the Specifications Manual.
Caterpillar Information System:
3208 MARINE ENGINE Governor
3208 MARINE ENGINE Fuel Injection Pump Housing
3208 MARINE ENGINE Fuel Transfer Pump
3208 MARINE ENGINE Fuel Injection Pumps
3208 MARINE ENGINE Shutoff Housing
3208 MARINE ENGINE Check Valve & Bypass Valve
3208 MARINE ENGINE Fuel Injection Pump Housing & Governor
3208 MARINE ENGINE Fuel Filter Base
3208 MARINE ENGINE Oil Filter Base
3208 MARINE ENGINE Engine Oil Cooler
3208 MARINE ENGINE Raw Water Pump
3208 MARINE ENGINE Water Temperature Regulators
3208 MARINE ENGINE Crankcase Ventilator
3208 MARINE ENGINE Rocker Shaft Assemblies & Push Rods
3208 MARINE ENGINE Fuel Injection Nozzles
3208 MARINE ENGINE Cylinder Head Assemblies
3208 MARINE ENGINE Oil Pan
3208 MARINE ENGINE Connecting Rod Bearings
3208 MARINE ENGINE Pistons & Connecting Rod Assemblies
3208 MARINE ENGINE Valve Lifters
3208 MARINE ENGINE Crankshaft Main Bearings
3208 MARINE ENGINE Crankshaft Pulley
3208 MARINE ENGINE Crankshaft Front Seal
3208 MARINE ENGINE Timing Gear Cover & Oil Pump