Limited Slip Differential - Disassemble - If Equipped
拆解步骤
Show/hide table
所需工具     | |||
---|---|---|---|
工具     | 零件号     | 零件描述     | 数量     |
A     | FT-2563     | 差速器调整     | 1     |
B     | 8T-5096     | 千分表总成     | 1     |
开始:
- 拆下前车桥。 请参阅拆解和组装, "前固定轴 - 拆卸"。
- 拆下后轴。 请参阅拆解和组装, "摆动桥(后)和耳轴支架 - 拆卸"。
注: 清洁度是一项重要的因素。 拆解步骤开始之前,应彻底清洁部件外部。 这有助于防止尘土进入内部结构。
注: 拆解前,单独测量全部两侧齿轮的端隙。 步骤 1 到 7 涵盖了测量端隙的程序。
- 将差速器组件放到台钳中。
Show/hide table
图 1 | g00490940 |
Show/hide table
图 2 | g00490943 |
Show/hide table
图 3 | g00490967 |
- 将工具 (A) 插入差速器组件的轮轴中,直到工具 (A) 穿过侧齿轮。
- 上紧工具 (A) 的螺母,使其足以将工具锁定到侧齿轮的内部台肩上。
注: 螺母上紧后,工具 (A) 的连杆必须自由移动。
- 将工具 (B) 安装到差速器组件上。
- 将工具 (B) 的千分表在工具 (A) 上归零。
- 将 40 N·m (30 lb ft) 的扭矩施加到工具 (A) 上。
注: 千分表读数便是伞齿轮对面侧齿轮的端隙测量值。
- 对另一侧重复步骤 1 到 6。
Show/hide table
图 4 | g00491000 |
- 记录两端隙。 如果测量值大于 0.66 mm (0.026 in),则更换盘组。
注: 步骤 9 到 25 用于拆解差速器。
- 拆下将伞齿轮 (2) 固定到差速器箱 (3) 上的螺栓 (1) 。
Show/hide table
图 5 | g00491040 |
- 将螺栓 (1) 装入差速器箱 (3) 中。
注: 不要拧紧螺栓 (1) 。 这样可防止差速器箱 (3) 掉落到地面上。
Show/hide table
图 6 | g00491082 |
- 利用适当的压具将伞齿轮 (2) 从差速器箱 (3) 上分离。
- 将伞齿轮 (2) 从差速器箱 (3) 上拆下。
Show/hide table
图 7 | g00491084 |
- 拆下盘组 (4) 。
Show/hide table
图 8 | g00491086 |
- 将隔套 (5) 从差速器箱上拆下。
Show/hide table
图 9 | g00491087 |
- 替代盘组由板 (6) 、摩擦盘 (7) 和隔套 (5) 组成。
Show/hide table
图 10 | g01055717 |
- 将垫片组 (8) 从侧齿轮 (9) 上拆下。
Show/hide table
图 11 | g00491092 |
- 用千分表测量垫片组的厚度。 为了便于安装,记录测量尺寸。
Show/hide table
图 12 | g00491093 |
- 将侧齿轮 (9) 从差速器箱上拆下。
注: 在所有零件上做好识别标记,以便于安装。 不要将零件错用到另一侧。
Show/hide table
图 13 | g00491096 |
- 利用适当的手锤和适当的冲头将定位销 (10) 从差速器箱上拆下。
Show/hide table
图 14 | g00491097 |
- 将小齿轮轴 (11) 和小齿轮轴 (12) 从差速器箱上拆下。
Show/hide table
图 15 | g00491099 |
Show/hide table
图 16 | g00491101 |
- 将小齿轮 (13) 、止推垫圈 (14) 和接头 (15) 从差速器箱上拆下。
Show/hide table
图 17 | g00491102 |
Show/hide table
图 18 | g00491104 |
- 将侧齿轮 (16) 从差速器箱上拆下。
Show/hide table
图 19 | g00491110 |
- 将垫片组 (17) 从侧齿轮 (16) 上拆下。
Show/hide table
图 20 | g00491111 |
- 利用千分表测量垫片组。 为了便于安装,记录测量尺寸。
Show/hide table
图 21 | g00491112 |
- 将隔套 (18) 从差速器箱上拆下。
Show/hide table
图 22 | g00491114 |
- 拆下盘组 (19) 。
Show/hide table
图 23 | g00491115 |
- 替代盘组由板 (20) 、摩擦盘 (21) 和隔套 (22) 组成。
注: 在所有零件上做好识别标记,以便于安装。 不要将零件错用到另一侧。
Show/hide table
图 24 | g01055721 |
Caterpillar Information System:
CB-334E and CB-335E Vibratory Compactors Propel System Case Drain Flow for Piston Motor (Wheel Propel) - Test
AP-655C and BG-2255C Asphalt Pavers Machine Systems Footshaft - Install
AP555E and BG555E Asphalt Pavers Machine Systems Footshaft - Assemble
AP555E and BG555E Asphalt Pavers Machine Systems Footshaft - Disassemble
AP-655C and BG-2255C Asphalt Pavers Machine Systems Footshaft - Remove
C13, C15, and C18 Generator Set Engines Engine Pressure Sensor Open or Short Circuit - Test
R1300G Load Haul Dump Power Train Oscillating Axle (Rear) to Output Transfer Gears - Connect
AP-1000B and BG-260C Asphalt Pavers Conveyor Systems Cooling Manifold
R1300G Load Haul Dump Power Train Oscillating Axle (Rear) from Output Transfer Gears - Separate
M325D L MH and M325D MH Material Handlers Hydraulic System Travel Brake Valve
CP-323C and CS-323C Paving Compactors Engine Supplement Air Cleaner - Remove and Install
247B, 247B2, 257B and 257B2 Multi Terrain Loaders Power Train Bogie Wheel - Install
2004/03/15 Addition to Operation and Maintenance Manual , "Every 500 Service Hours or 3 Months" {4251}
914G and 914G2 Compact Wheel Loaders and IT14G and IT14G2 Integrated Toolcarriers Power Train Limited Slip Differential - Assemble - If Equipped
2004/03/08 Improved Gasket for the Engine Oil Cooler {1378, 7555}
2004/03/01 Improved Gasket for the Engine Oil Cooler {1378, 7555}
914G and 914G2 Compact Wheel Loaders and IT14G and IT14G2 Integrated Toolcarriers Power Train Oscillating Axle (Rear) and Trunnion Support - Remove
914G and 914G2 Compact Wheel Loaders and IT14G and IT14G2 Integrated Toolcarriers Power Train Oscillating Axle (Rear) and Trunnion Support - Install
TH350B, TH360B, TH460B and TH560B Telehandlers Machine Systems Hydraulic Tank
2004/06/14 A New Hoist Pump Is Now Available {5083}
AP-1055B and BG-2455C Asphalt Pavers Equipment Lowering with Engine Stopped
AP-1000B and BG-260C Asphalt Pavers Equipment Lowering with Engine Stopped
966H and 972H Wheel Loaders Automatic Lubrication Grease Tank - Fill - Autolube - If Equipped
247B and 257B Multi Terrain Loaders Machine Systems Pilot Hydraulic System