Rear Power Take-Off (RPTO) - Install - If Equipped
Show/hide table
| 所需工具 | |||
|---|---|---|---|
| 工具 | 零件号 | 零件描述 | 数量 |
| A | 1P-0520 | 冲头总成 | 1 |
Show/hide table
| 注意 |
|---|
|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 使用工具 (A) 将套筒轴承 (12) 安装到飞轮壳体中。 套筒轴承上的裂缝位置应保持角度 (Y)，即距竖直中心线 15 ± 1 度。 轴承应安装至深度 (Z)，即
2.0 ± 0.5 mm (0.08 ± 0.02 inch) 。 - 将盖 (10) 和螺栓安装在飞轮壳体的背面。
Show/hide table
图 2 g01134279 - 使用工具 (A) 将套筒轴承 (11) 安装到飞轮壳体中。 套筒轴承上的裂缝位置应保持角度 (X)，即距竖直中心线 15 ± 1 度。 轴承应安装至深度 (Z)，即
2.0 ± 0.5 mm (0.08 ± 0.02 inch) 。 - 将盖 (9) 和螺栓安装在飞轮壳体的背面。
Show/hide table
图 3 g01134263 - 使用工具 (A) 将套筒轴承 (8) 安装到接头 (2) 中。 将 O 形密封圈安装在接头上。
Show/hide table
图 4 g01134262 - 将齿轮组件 (6) 和齿轮组件 (7) 安置在飞轮壳体中。
Show/hide table
图 5 g01115921 - 安置惰齿轮 (5) 和护圈组件 (4)。 安装螺栓 (3)。 拧紧螺栓 (3) 至扭矩为
100 ± 20 N·m (74 ± 15 lb ft) 。 - 使用清洁的发动机机油润滑接头上的 O 形密封圈。 将接头 (2) 安置在飞轮壳体上，安装螺栓 (1)。
Show/hide table
| |
| 图 1 | g01134277 |
结束:
- 安装飞轮。 请参阅拆解和组装, "飞轮 - 安装"。
Caterpillar Information System:
914G and 914G2 Compact Wheel Loaders and IT14G and IT14G2 Integrated Toolcarrier Hydraulic System Kickout and Positioner - Adjust
C15 and C18 Engines for Caterpillar Built Machines Rear Power Take-Off (RPTO) - Remove - If Equipped
D250E Series II and D300E Series II Articulated Trucks Steering, Suspension, and Body Hoist Hydraulic Systems Hoist Control Valve
446D Backhoe Loader Hydraulic and Steering System Signal Resolver Network
CP-323C and CS-323C Paving Compactors Cooling System Coolant Extender (ELC) - Add
735 Articulated Truck Suspension System - Check
247B, 257B, 267B, 277B and 287B Multi Terrain Loaders and 216B, 226B, 232B, 236B, 242B, 246B, 248B, 252B, 262B and 268B Skid Steer Loaders Auxiliary Hydraulic Electronic Control System MID 106 - CID 1935 - FMI 04
CB-214E, CB-224E and CB-225E Paving Compactors Seat
2004/03/15 A Seal Kit for the Retract Section of the Hydraulic Pump Is Now Available {5055, 5070}
2004/03/15 Changes to the Steering System {4300}
2003/12/29 A New Retaining Ring Is Now Used in the Forward Low and Reverse Clutches {3155}
2003/12/29 New Retaining Ring in Gear Clutch Is Now Used. {3155}
248B and 268B Skid Steer Loaders Engine Supplement Radiator and Hydraulic Oil Cooler - Install
420D, 430D, 432D and 442D Backhoe Loaders Auxiliary Hydraulic Electronic Control System Normal Operation
914G2 and IT14G2 Compact Wheel Loaders Radiator Core - Clean
M325D and M330D Excavators Power Train Electronic Control System General Information
CP-323C and CS-323C Paving Compactors Cooling System Water Temperature Regulator - Replace
D250E Series II and D300E Series II Articulated Trucks Steering, Suspension, and Body Hoist Hydraulic Systems Relief Valve (Hoist)
914G and 914G2 Compact Wheel Loaders and IT14G and IT14G2 Integrated Toolcarrier Hydraulic System Hydraulic Accumulator (Pilot Oil) - Test and Charge
914G and 914G2 Compact Wheel Loaders and IT14G and IT14G2 Integrated Toolcarrier Hydraulic System Ride Control Accumulator - Test and Charge
C13, C15, and C18 Generator Set Engines E199 Low Coolant Temperature
IT14G Integrated Toolcarrier and 914G Wheel Loader Steering System Secondary Steering Valve - If Equipped
420D, 430D, 432D and 442D Backhoe Loaders Auxiliary Hydraulic Electronic Control System Electronic Control Module (ECM)
C13, C15, and C18 Generator Set Engines E360 Low Engine Oil Pressure