Auxiliary Water Pump - Remove - Type 1 and Type 2
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove clamp (1) and clamp (2) from auxiliary water pump (5).
- Attach a suitable lifting device to auxiliary water pump (5). The weight of auxiliary water pump (5) is approximately
23 kg (50 lb) . - Remove nuts (3).
- Remove auxiliary water pump (5) from the front housing.
- Remove gasket (4) from the front housing.
Show/hide table
Illustration 1 | g01066044 |
Caterpillar Information System:
3406E and 3456 Generator Set Engines User Defined Shutdown Input Circuit - Test
3126B Petroleum Engine Intermittent Low Power or Power Cutout
Product Link - PL102C Service Tools
C15 Petroleum Engines Engine Oil Pump - Install
C15 Petroleum Engines Engine Oil Pump - Remove
3126B Petroleum Engine Intermittent Engine Shutdown
3406E and 3456 Generator Set Engines Digital Sensor Supply Circuit - Test
G3520C and G3520E Generator Set Engines Generator Output Power Readings Do Not Match
2004/05/01 Procedure to Allow Clearance to Install an Eaton VCTplus Clutch {1156}
3406E and 3456 Generator Set Engines CAT Data Link Circuit - Test
3406E and 3456 Generator Set Engines Analog Sensor Supply Circuit - Test
C18 Generator Set Safety Messages
C18 Generator set and C18 Marine Engines Auxiliary Water Pump - Install - Type 1 and Type 2
C18 Generator set and C18 Marine Engines Auxiliary Water Pump - Remove - Rubber Impeller
C18 Generator set and C18 Marine Engines Auxiliary Water Pump - Install - Rubber Impeller
Product Link - PL102C Position Reports Not Available
Product Link - PL102C Reporting Interval Erratic
C18 Generator Set Reference Material
C-15 Petroleum Engine Engine Oil Pan - Remove and Install
3406E and 3456 Generator Set Engines Speed Control (Switch) - Test
C-15 Petroleum Engine Engine Oil Cooler - Remove
C-15 Petroleum Engine Engine Oil Cooler - Install
C15 and C18 Tier 4 Final Engines Increased Engine Oil Temperature - Inspect
345C MHPU Mobile Hydraulic Power Unit Belt - Inspect/Adjust/Replace