Engine Oil Pump - Remove
Start By:
- Remove the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install".
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove bolts (1). Remove tube assembly (2). Remove the O-ring seal from the tube assembly.
- Remove bolt (8) and the washer.
- Remove bolts (4). Remove suction bell assembly (5) and tube assembly (7). Remove the O-ring seal from the tube assembly.
- If necessary, remove bolts (6) and remove tube assembly (7) from suction bell assembly (5).
- Remove bolts (9) and remove engine oil pump (3) from the cylinder block.
- If necessary, remove the bolts, the plate, and the gasket from the bottom of the cylinder block.
Show/hide table
| |
| Illustration 1 | g01065889 |
Caterpillar Information System:
3126B Petroleum Engine Intermittent Engine Shutdown
3406E and 3456 Generator Set Engines Digital Sensor Supply Circuit - Test
G3520C and G3520E Generator Set Engines Generator Output Power Readings Do Not Match
2004/05/01 Procedure to Allow Clearance to Install an Eaton VCTplus Clutch {1156}
3406E and 3456 Generator Set Engines CAT Data Link Circuit - Test
3406E and 3456 Generator Set Engines Analog Sensor Supply Circuit - Test
C18 Generator Set Safety Messages
C-15 Petroleum Engine Vibration Damper - Check
3126B Marine Engines Analog Sensor Supply Circuit - Test
C15 and C18 Industrial Engines Flywheel Adapter - Remove and Install
C18 Industrial Engines Plate Locations and Film Locations
C15 Petroleum Engines Flywheel - Install
C15 Petroleum Engines Engine Oil Pump - Install
Product Link - PL102C Service Tools
3126B Petroleum Engine Intermittent Low Power or Power Cutout
3406E and 3456 Generator Set Engines User Defined Shutdown Input Circuit - Test
C18 Generator set and C18 Marine Engines Auxiliary Water Pump - Remove - Type 1 and Type 2
C18 Generator set and C18 Marine Engines Auxiliary Water Pump - Install - Type 1 and Type 2
C18 Generator set and C18 Marine Engines Auxiliary Water Pump - Remove - Rubber Impeller
C18 Generator set and C18 Marine Engines Auxiliary Water Pump - Install - Rubber Impeller
Product Link - PL102C Position Reports Not Available
Product Link - PL102C Reporting Interval Erratic
C18 Generator Set Reference Material
C-15 Petroleum Engine Engine Oil Pan - Remove and Install