Vibration Damper - Check
Show/hide table
 | |
| Illustration 1 | g01065247 |
Viscous vibration damper (1) Crankshaft hub (2) Crankshaft pulley (3) Weight (4) Case | |
Show/hide table
| NOTICE |
|---|
Inspect the viscous vibration damper for signs of leaking and for signs of damage to the case. Either of these conditions can cause the weight to contact the case. This contact can affect damper operation. |
Damage to the vibration damper or failure of the vibration damper will increase engine vibrations. This will result in damage to the crankshaft.
Replace the damper if any of the following conditions exist:
- The damper is dented, cracked, or fluid is leaking from the damper.
- The paint on the damper is discolored from excessive heat.
- The damper is bent.
- The bolt holes are worn or there is a loose fit for the bolts.
- The engine has had a crankshaft failure due to torsional forces.
Caterpillar Information System:
3126B Marine Engines Analog Sensor Supply Circuit - Test
C15 and C18 Industrial Engines Flywheel Adapter - Remove and Install
C18 Industrial Engines Plate Locations and Film Locations
C15 Petroleum Engines Flywheel - Install
C15 Petroleum Engines Flywheel - Remove
C-15 Petroleum Engine Cooling System - Check - Overheating
G3520C and G3520E Generator Set Engines Auxiliary Water Pump - Assemble
G3520C and G3520E Generator Set Engines Auxiliary Water Pump - Disassemble
G3516B Engines MID 036 - CID 1719 - FMI 04 Generator Output Power Sensor short to ground
G3516B Engines MID 036 - CID 1719 - FMI 03 Generator Output Power Sensor open/short to +batt
3406E, C-10 and C-12 On-highway Engines Check Engine Lamp Circuit - Test
3406E, C-10 and C-12 On-highway Engines Engine Shutdown Output Circuit - Test
C18 Generator Set Safety Messages
3406E and 3456 Generator Set Engines Analog Sensor Supply Circuit - Test
3406E and 3456 Generator Set Engines CAT Data Link Circuit - Test
2004/05/01 Procedure to Allow Clearance to Install an Eaton VCTplus Clutch {1156}
G3520C and G3520E Generator Set Engines Generator Output Power Readings Do Not Match
3406E and 3456 Generator Set Engines Digital Sensor Supply Circuit - Test
3126B Petroleum Engine Intermittent Engine Shutdown
C15 Petroleum Engines Engine Oil Pump - Remove
C15 Petroleum Engines Engine Oil Pump - Install
Product Link - PL102C Service Tools
3126B Petroleum Engine Intermittent Low Power or Power Cutout
3406E and 3456 Generator Set Engines User Defined Shutdown Input Circuit - Test