Engine Oil Pump - Install
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- If necessary, install the gasket, the plate, and the bolts on the bottom of the cylinder block.
Show/hide table
Illustration 1 g01065889 - Position engine oil pump (3) on the dowels in the cylinder block. Install bolts (9).
Note: Ensure that the engine oil pump is seated on the dowels before the bolts are tightened.
- If necessary, position tube assembly (7) on suction bell assembly (5) and install bolts (6).
- Install the O-ring seal on tube assembly (7). Lubricate the bore in the engine oil pump with clean engine oil. Install tube assembly (7) in the engine oil pump. Install the washer and bolt (8).
- Position suction bell assembly against the cylinder block and install bolts (4).
- Install the O-ring seal on tube assembly (2). Lubricate the bore in the engine oil pump with clean engine oil. Install tube assembly (2) in the engine oil pump. Install bolts (1).
End By:
- Install the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install".
Caterpillar Information System:
C15 Petroleum Engines Engine Oil Pump - Remove
3126B Petroleum Engine Intermittent Engine Shutdown
3406E and 3456 Generator Set Engines Digital Sensor Supply Circuit - Test
G3520C and G3520E Generator Set Engines Generator Output Power Readings Do Not Match
2004/05/01 Procedure to Allow Clearance to Install an Eaton VCTplus Clutch {1156}
3406E and 3456 Generator Set Engines CAT Data Link Circuit - Test
3406E and 3456 Generator Set Engines Analog Sensor Supply Circuit - Test
C18 Generator Set Safety Messages
C-15 Petroleum Engine Vibration Damper - Check
3126B Marine Engines Analog Sensor Supply Circuit - Test
C15 and C18 Industrial Engines Flywheel Adapter - Remove and Install
C18 Industrial Engines Plate Locations and Film Locations
Product Link - PL102C Service Tools
3126B Petroleum Engine Intermittent Low Power or Power Cutout
3406E and 3456 Generator Set Engines User Defined Shutdown Input Circuit - Test
C18 Generator set and C18 Marine Engines Auxiliary Water Pump - Remove - Type 1 and Type 2
C18 Generator set and C18 Marine Engines Auxiliary Water Pump - Install - Type 1 and Type 2
C18 Generator set and C18 Marine Engines Auxiliary Water Pump - Remove - Rubber Impeller
C18 Generator set and C18 Marine Engines Auxiliary Water Pump - Install - Rubber Impeller
Product Link - PL102C Position Reports Not Available
Product Link - PL102C Reporting Interval Erratic
C18 Generator Set Reference Material
C-15 Petroleum Engine Engine Oil Pan - Remove and Install
3406E and 3456 Generator Set Engines Speed Control (Switch) - Test