CID 0164 FMI 04 Injector Actuation Pressure voltage low
Conditions Which Generate This Code:
The Electronic Control Module (ECM) detects the following conditions:
- The voltage signal from the injection actuation pressure sensor is below 0.1 VDC for one second.
- The ECM has been powered for at least three seconds.
System Response:
The ECM will log the diagnostic code. The ECM flags injection actuation pressure as invalid data and a default value of 12 MPa (1740 psi) is used.
- Low power
Test Step 1. Perform the following diagnostic procedure: Engine Sensor Open/Short Circuit- Test
Results:
- OK - STOP
Caterpillar Information System:
C13, C15, and C18 Generator Set Engines Engine Cranks but Will Not Start
G3408 and G3412 Engines Overhaul (Top End)
G3408 and G3412 Engines Overhaul (Major)
G3408 and G3412 Engines Starting with Jump Start Cables
3406E, C-10 and C-12 On-highway Engines Vehicle Wiring Harness Diagram
3406E, C-10 and C-12 On-highway Engines Engine Wiring Harness Diagram
C18 Generator Set Model View Illustrations
2004/11/01 Jacket Water Heaters for Truck Engines and On-highway Engines {1383}
C18 Power Module Refill Capacities and Recommendations
C18 Generator Set Self-Diagnostics - EMCP II or EMCP II+ (If Equipped)
3412E Petroleum Engine CID 0105 FMI 04 Inlet Manifold Temp Sensor short to ground
3412E Petroleum Engine CID 0105 FMI 03 Inlet Manifold Temp Sensor open/short to +batt
3508B, 3512B, and 3516B High Displacement Generator Sets Starting with Jump Start Cables
3406E, C-10 and C-12 On-highway Engines Customer Specified Parameters
C13, C15, and C18 Generator Set Engines Engine Will Not Crank
C13, C15, and C18 Generator Set Engines Intermittent Engine Shutdown
C15 and C18 Industrial Engines Front Cover - Remove
C13, C15, and C18 Generator Set Engines Low Power/Poor or No Response to Throttle
C15 and C18 Industrial Engines Front Cover - Install
C9 Urban Transit Bus Engine 0071-11 Engine Shutdown Override Switch Occurrence
3406E, C-10 and C-12 On-highway Engines Customer Specified Parameters Table
G3408C and G3412C Engines Engine Oil and Filter - Change
C13, C15, and C18 Generator Set Engines Event Codes
G3408C and G3412C Engines Overhaul (Major)