CID 0105 FMI 03 Inlet Manifold Temp Sensor open/short to +batt
Conditions Which Generate This Code:
The ECM detects a signal voltage from the inlet air temperature sensor that is greater than 4.8 volts.
System Response:
The ECM flags inlet air temperature as invalid data and a default value of −40 °C (−40 °F) is used.
- Hard starting
- Low power
Test Step 1. Perform the following diagnostic procedure: Engine Sensor Open/Short Circuit - Test
Results:
- OK - STOP
Caterpillar Information System:
C18 Generator Sets Product Storage
C18 Generator Set Product Lifting
C15 Petroleum Engines Water Temperature Regulator - Remove and Install
3406E, C-10 and C-12 On-highway Engines Sensors and Electrical Connectors
3126B Petroleum Engine Low Power/Poor or No Response to Throttle
C18 Generator Set Plate Locations and Film Locations
3126B Petroleum Engine Excessive Fuel Consumption
3126B Petroleum Engine Excessive Black Smoke
3126B Petroleum Engine Engine Oil Temperature Is Too High
3412E Petroleum Engine Engine Cranks but Will Not Start
3406E, C-10 and C-12 On-highway Engines System Overview
C13, C15, and C18 Generator Set Engines Digital Sensor Supply Circuit - Test
3412E Petroleum Engine CID 0105 FMI 04 Inlet Manifold Temp Sensor short to ground
C18 Generator Set Self-Diagnostics - EMCP II or EMCP II+ (If Equipped)
C18 Power Module Refill Capacities and Recommendations
2004/11/01 Jacket Water Heaters for Truck Engines and On-highway Engines {1383}
C18 Generator Set Model View Illustrations
3406E, C-10 and C-12 On-highway Engines Engine Wiring Harness Diagram
3406E, C-10 and C-12 On-highway Engines Vehicle Wiring Harness Diagram
G3408 and G3412 Engines Starting with Jump Start Cables
G3408 and G3412 Engines Overhaul (Major)
G3408 and G3412 Engines Overhaul (Top End)
C13, C15, and C18 Generator Set Engines Engine Cranks but Will Not Start
3408E and 3412E Engines for Caterpillar Built Machines CID 0164 FMI 04 Injector Actuation Pressure voltage low