Illustration 1 | g01128314 |
There may be several specific safety messages on your engine. The exact location and a description of the messages are reviewed in this section. Please become familiar with all of the messages.
Ensure that all of the messages are legible. Clean the messages or replace the messages if the words cannot be read or if the illustrations are not visible. Use a cloth, water, and soap for cleaning the messages. Do not use solvents, gasoline, or other harsh chemicals. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the messages. The messages that are loosened could drop off of the engine.
Replace any message that is damaged or missing. If a message is attached to a part of the engine that is replaced, install a new message on the replacement part. Your Caterpillar dealer can provide new messages.
Do not operate or work on this engine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manual. Failure to follow the instructions or heed the warnings could result in injury or death. Contact any Caterpillar dealer for replacement manuals. Proper care is your responsibility. |
The safety messages that may be attached on the engine are illustrated and described below.
This safety message is located near the front of the expansion tank.
Illustration 2 | g01128325 |
Pressurized System: Hot coolant can cause serious burn. To open cap, stop engine, wait until radiator is cool. Then loosen cap slowly to relieve the pressure. |
The safety message for reading the manual is located on the cover of the junction box.
Illustration 3 | g00903032 |
Do not operate or work on this engine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manual. Failure to follow the instructions or heed the warnings could result in injury or death. Contact any Caterpillar dealer for replacement manuals. Proper care is your responsibility. |
The safety message for an improper jumper cable connection is located near the batteries.
Illustration 4 | g00296980 |
IMPROPER JUMPER CABLE CONNECTIONS CAN CAUSE EXPLOSION RESULTING IN PERSONAL INJURY. BATTERIES MAY BE LOCATED IN SEPARATE COMPARTMENTS. WHEN USING JUMPER CABLES, ALWAYS CONNECT POSITIVE (+) CABLE TO POSITIVE (+) TERMINAL OF BATTERY CONNECTED TO STARTER SOLENOID AND NEGATIVE (-) CABLE FROM EXTERNAL SOURCE TO STARTER NEGATIVE (-) TERMINAL (IF MACHINE NOT EQUIPPED WITH STARTER NEGATIVE TERMINAL, CONNECT TO ENGINE BLOCK.) FOLLOW PROCEDURE IN THE OPERATION MANUAL. |